I spend a lot of time up in my office and have gradually been transforming it into a Classic Cadillac Office! Here is where I run Classic Cadillac Parts, Direct the CLC 1963/64 Cadillac Chapter, and Hold down the Fort! I have a long way to go, but thought I would share my Wall of Self-Starters that runs down one 32 foot wall of my office. Thanks to CLC President Lars Kneller, and Carolina Region Director Travis Dowell, for contributing to my Cadillac Obsession. I now have every Cadillac & LaSalle Club Self-Starter from Feb 1961 forward, and hope to fill the 1959/60 gap at some point! Anyway, Here is a peak into my Cadillac Office.

I have posted 3 pictures here but have more posted on my Facebook page which you can see by Clicking Here.


Facebook Facebook

Views: 220

Reply to This

Replies to This Discussion

Very tidy Jason..... almost too tidy. No OCD in your family. LOL

Hmmm, I can just picture a visiting Aussie messing that up during a visit in.... oh... I dunno..... maybe around 5 months time :-)

Nice office Jason, your definitely a Cadillac guy. 

It is a work in progress. Just really getting started but since I have  most of my Self-Starter's in place thought I would show you guys down at least one wall. Big changes coming next when I start moving my tall book shelves off the raised center desk "Control Center" to the back wall!

A Cadillac Crazy following a Cadillac Crazy following a Cadillac Crazy! Doesn't sound too Crazy to Me!
Your Cadillac Crazy!

RSS

Photos

  • Add Photos
  • View All

Forum

Power steering fluid

Started by Bobby Brown in General Discussion. Last reply by Dennis P. DiBari 7 minutes ago. 1 Reply

My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue

Dino Diaries - July 11, 2025 - Busted!

Started by Jason Edge in General Discussion. Last reply by Jason Edge yesterday. 4 Replies

So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Thursday. 3 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service