I was considering adding this petronics system  to the 63 model.....

advantages //// disadvantages?  

keep in mind, i am complete novice,,

Sincerely

Kim

Facebook Facebook

Views: 148

Reply to This

Replies to This Discussion

Don't have to adjust points. If installing a new coil as well you will get higher voltage = better spark.

Read these three links and you should be good to go:

Pertronix Ignitor Ignition & Flamethrower I, II, and III Compar...

Pertronix Ignitor II and Flame Thrower II installation

Resistance wire removal or replacement

Petronix 3 Kim - just remember you need to rewire in full 12 volts for the petronix ignition itself (inside the dizzy) and the coil but you pick that up off the battery and use the ignition voltage signal to switch the relay.  With the 64 429s its pretty easy with the dizzy at the front.  I did one for a friend with a 59 and it was a pain getting to the dizzy at the back of the engine = you have to stand inside the engine bay to reach down inside and wire it all in!  overall though a great ignition system!

John

RSS

Photos

  • Add Photos
  • View All

Forum

Dino Diaries - July 11, 2025 - Busted!

Started by Jason Edge in General Discussion. Last reply by Jason Edge 16 hours ago. 4 Replies

So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Thursday. 3 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Getting hot when going fast…

Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 6 Replies

So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service