I've discover the previous owner of my 64 reversed the locations of the muffler and resonator; the resonator is under the driver and the muffler is in the rear. I've just received a new system from Classic Exhaust in Ohio but it came without hangers. My question is where can I find the original style hangers for the exhaust system?
Facebook Facebook

Views: 284

Reply to This

Replies to This Discussion

I have some of the stock hangers.   Shoot me an email to;  russ85747@hotmail.com   Not sure of a new source though.

Bob I puchased the same system I believe from eBay. If your doing it yourself don't slide the pipes into each other to far and it'll go on fine. You will need two people to make the job easier or you can slowly snug up each pipe clamp so it will hold in place as you adjust it but still not move.

I will say I'm not totally happy with the sound as I find its a bit loud and the resonator is a homemade job. I was looking for stock replacement for quietness and it is far off.

I looked up waldrons exhaust on line. That would be great if they had new pieces.  I didn't see hangars specifi for the 63/64, but it was late, and one would need to call them.

So I called Waldron’s Exhaust and they do have new OEM style hangers. They have very few in stock and get from a third party when needed. I order a set which should arrive in 2 weeks.

Are you talking about the entire bracket assemblies are just the U bolt, 2 nuts and cradle clamp. the complete hanger assemblies are quite different and quite elaborate.

Here is the first bracket assembly behind the muffler:

And here's the 2nd  toward the center:

Here is one showing the rear section

I specifically asked for the 3 hanger assemblies as shown in the pictures and they said they have them for the muffler, center and the one in the rear at the resonator. We'll see what shows up at my doorstep in about 2 weeks.

Let us know if they are an exact reproduction. I might get a set for my Caddy.

That's great to hear. Hopefully it will be a good setup.  Please keep us posted with pics.

Jason, thanks for the original pics.

RSS

Photos

  • Add Photos
  • View All

Forum

Rear main seal

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Phillip Hill 2 hours ago. 4 Replies

Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue

Logans Intake Project, 1964 Fleetwood, Progress Report #1

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb 20 hours ago. 3 Replies

I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue

1963 Cadillac differential 3.25

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Thursday. 2 Replies

I have a 1963 Cadillac differential with 80K on it. Found a limited slip a while back, and I do not think I will ever used the original diff.  In is in carlsbad California 92009.  Let me know if you…Continue

headlight / dimmer switch confusion (63 Sedan Deville)

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 3 Replies

The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service