Hey all, has anyone had their windshield removed and resealed successfully. I'm pretty skittish about having someone mess with my perfectly good glass knowing that these cars are a little different than the new junk. It leaks in 3-4 places when going down the hiway.  Also worried about them screwing up the trim around the windshield. Maybe I'm just being over protective since its hard to find competent techs on this old stuff.

Thanks 

Tom B

Facebook Facebook

Views: 105

Reply to This

Replies to This Discussion

Your concerns are valid. I suggest that you do THOROUGH research and pick a shop that specializes in older cars with gasket-seal windshields. After my car was painted I needed to have my windshield installed. I found a shop nearby that SAID they could do it (lesson learned, I should have done more research). They even had a vintage car on their website. Long story short, after bringing it back 3 times, I wound up with a leaky windshield and damaged trim. Like several other things I want done right, I ended up just doing it myself. The most important thing is finding the right sealant. This stuff is like a tar or clay that does not skin-over or cure. If you find a good shop that can actually do it right, it probably won't be cheap. It is quite a task.

Thanks all for the comments. Its kind of what I suspected. 

Tom B

RSS

Photos

  • Add Photos
  • View All

Forum

Wanted Cadillac Lasalle 2 inch Windshield Decal Sticker

Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari 9 hours ago. 3 Replies

for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Sunday. 2 Replies

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service