I'm doing a resto mod on a 63 deville and I want to use the stock drive train instead of an ls swap like everyone else would. The problem I'm running into right now is I have no power under load. When cold it revs fine and sounds good but when under a load and warmed it it falls on its face and won't get out of its own way. Timing was set with a light and carb was roughed in and is close (edelbrock 600cfm) so I'm running out of ideas. Broken vacuum advance? Weak fuel pump?

Views: 91

Reply to This

Replies to This Discussion

The carb is running lean, bump it up 2 steps for cruise and power. 

Hi James,

Russ makes a great point.  You might be running too lean - open the adjusters a bit.  You can also check your vacuum advance with the timing light attached; reattach the vacuum and see if it advances with the car running.  One last thing, how is  the transmission fluid?  Make sure it's clean and at correct level.  Hope this helps.

Dennis DiBari, Cottekill, NY

The 2 adjusters are for idle only. You will need to swap out the metering rods and possibly the jets. Go to this link as it is the chart to adjust your 600 cfm carb.  The stock carb is at #1 in the middle.  You need to go rich so go to the right by 2 steps. Depending on the number, you will swap rods or jets.  Find the number and check below to see what is needed to be swapped. You can buy a rod & jet kit at the parts stores or on line. 

Now this is very important as you will burn a piston. I worked on a 64 that had a stock 750 cfm put on it by a shop.  It was at stock calibration and ran lean and burned the ring skirt off of 2 pistons.  The engine had to be rebuilt. 

I changed out the metering rods, re timed and re adjusted the carb and took the car down the road again. Things started out better but when I turned around about a mile down the road it was back to the same old problems. No power, wouldn't Rev up while in gear or in park. Gonna check compression just to rule it out but I'm starting to suspect it might be a transmission issue. Could it be?

Have you replaced the fuel filter? That's always a good place to start.  

Check the coil, it may be going bad. Also the condenser. 

If it seems to be starving for fuel underload, you need to check your fuel lines from the tank to the carb. At the tank are rubber lines to the metal feed lines. They are notorious for dry rotting after 60 years, with age cracks that create a siphoning effect making it harder for the fuel pump to pull gas (sort of like sucking soda through a straw with a hole in it). Check all hose clamps, metal lines, then the rubber lines at the front feeding to fuel pump and filter vapor return line (if AC equipped). Check main fuel filter, but also check the inlet screen at the carb. Where the metal line attached to the carb, there is first an inlet screen. Anything that gets past a compromised fuel filter gets trapped here and can limit gas flow. Here is a picture of one below. Also, if you have a stock glass filter, the glass jar should  stay full once the car fires up. Most cars will hold the fuel up in the bowl for a few days. If it quickly leaks back down that can indicate a problem in the aforementioned areas.

PS. This picture might have been a good "What Is It" Trivia as many might not be aware of it!  You will become aware of if it gets clogged!!

That's the culprit!  Jason's right in checking EVERYTHING that delivers fuel to the intake manifold.

It might be a slight fix here, a slight fix there, but it adds up. 

RSS

Photos

  • Add Photos
  • View All

Forum

wiper blade refills.

Started by Russ Austin in 1963/64 Cadillac Specific Discussion 13 hours ago. 0 Replies

I picked up a batch of wiper blade refills. 18 inch refill set for $20.00 plus shipping.Please email me at russ@thecadishack.comContinue

Window Frame removal

Started by Dominic Salemi in General Discussion. Last reply by Dominic Salemi 17 hours ago. 2 Replies

Has anyone removed the window frames from the doors. I want to get my frames re chromed and need to remove all windows, I did not see a "help" topic on this. Has anyone done this before? I would…Continue

engine compartment color

Started by Scott Santora in Restoration Discussion. Last reply by Scott Santora yesterday. 2 Replies

 My car's paint code is 10, Ebony Black. Does anybody know if Eastwood's "Original Chassis Black Satin" is the correct engine compartment color? I only need to do some touch-up and at least for right…Continue

2025 calendars are ordered.

Started by Russ Austin in General Discussion yesterday. 0 Replies

The 2025 63 64 Cadillac wall calendars have just been designed and ordered. I only order 50 and I sell out each year, so get yours early to guarantee a calendar.$15.00 plus shipping. Please email me…Continue

Blog Posts

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service