Please post a pic of door panel
Replies to This Discussion
-
Permalink Reply by Jason Edge on
-
On the side perimeter, those are small ring-shank like nails that go through the metal strip on inner edge of door panel. On my 64CDV I actually used small ring shank nails from Home Depot to drive thru door panel and into insert for the few I was missing.
-
Permalink Reply by 3acmvkzaxjk7y on
-
Phil--
Who rebuilt your door panels? Mine were done in the not-too-distant past but aren't an original pattern. I'd like to go back to proper door panels.
Thanks,
David
-
-
Thanks Jason! That door has the same long slot as the 61-62 have that the water proof paper goes into. In the next few weeks I will stop by Rubber the Rightway store and get a photo of their water proof paper.
-
Permalink Reply by Phil Jakubowski on
-
Not sure if mine are original pattern either. They matched what I brought in just made them new
-
-
Door panel pic finally
- Attachments:
-
-
14652985600291804845474.jpg, 4.9 MB
-
-
-
Good job on the door panel.
-
-
Looks great!
- ‹ Previous
- 1
- 2
- Next ›
Photos
Members
Forum
Cool Item from Batch of Parts I Just Picked Up
Started by Jason Edge in General Discussion. Last reply by Logan Robb 2 minutes ago. 1 Reply 0 Likes
I recently picked up a rather large batch of parts from a contact that has sold their 63 and had left over parts. Here was one item I pulled that make me smile - a 1963 Indiana License Plate. For…Continue
T3 Headlights
Started by Jeff Donaldson in General Discussion. Last reply by Jeff Donaldson 9 hours ago. 3 Replies 0 Likes
Has anyone bought new oem headlights from Lectric Limited? They want $150 for a set of new remanufactured ones. Any advice would be appreciated.JeffContinue
Troubleshooting drivability
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 5 Replies 0 Likes
Hey everyone. Last year I had some trouble keeping the Caddy running. A little backstory, car hadn’t ran in 30 years. Rebuilt the crankshaft. I had it running pretty well for a bit. Even drove it the…Continue
Blog Posts
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 0 Likes
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Vintage Air AC
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 1 Like
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
accumulator dryer
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
'63 Eldorado trumpet horn + 2 standard horns restoration
Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment 0 Likes
My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns.
There is a restoration service called The Horn Works who my son…
ContinueEvents
© 2024 Created by Jason Edge.
Powered by
