water pumps
my pump has gone out again in 63, 390. I dont know why, either too tight a belt or something else, been 2 or three since rebuild and 13k miles.. it was a gates unit. it seems for a while the cordone unit was the only one out there with the enclosed impeller but apparently, they are no longer available anywhere, even there company site doesn't list them. While searching, I found that rock auto now has a supplier with the enclosed impeller, https://www.usmotorworks.com/catalog/ through rock auto.. may give it a try,, anyway, its just for info as the enclosed impeller has been hard to come by, not sure it makes a difference, but I think its what was on the original motors..
Replies to This Discussion
-
Permalink Reply by Phillip Hill on
-
Hey Kim probably Chinese made junk
-
Permalink Reply by 3ft7bqmb7dryo on
-
The enclosed impeller is what was on the original water pumps. What are you putting in your radiator? The coolant acts as a lubricant for the water pump.
-
-
I used on of the 50/50 antifreeze products out there,
Members
Forum
where to find 1963 Cadillac Plastic Door Pin Anchors
Started by Frank Murch in 1963/64 Cadillac Specific Discussion 5 hours ago. 0 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Rear Main Seal Oil Leak Fix with Bearing Cap Modification
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth 8 hours ago. 15 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Future of CLC Judging
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge on Thursday. 6 Replies 0 Likes
First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system. The old system was very good, however, I believe what Bill and the…Continue
front seat crest
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Tuesday. 3 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
