I have a series 62 1963 convertible and under the left fender, near the firewall is a vacuum tank with a "T" and 2 hoses.  On e is disconnected, WHERE do it go????

Thanks

Facebook Facebook

Views: 239

Attachments:

Reply to This

Replies to This Discussion

That is for the power door locks. 

I guess this does directly to the intake manifold?

The large vacuum tank on firewall on left side under left fender is used for cars equipped with vacuum power trunk or vacuum power door locks. The one hose feeds straight back into the cabin for trunk lock and/or door lock operation, while the other line goes across over to the fitting on the back of the intake. 

That back of intake on 63 cars usually has 3 nipples: one goes back up to the connector in center of the large forward wiring harness connector on firewall that in turn feeds Neutral Safety Switch and heat or heat/AC system; one goes up to the vacuum throttle check valve mounted to the throttle relay bracket on firewall; and the 3rd goes over to the power door lock/power trunk vacuum canister in your picture. 

RSS

Photos

  • Add Photos
  • View All

Forum

Dino Diaries - July 11, 2025 - Busted!

Started by Jason Edge in General Discussion 8 hours ago. 0 Replies

So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin yesterday. 3 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Getting hot when going fast…

Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 6 Replies

So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service