Temperature gauge not working properly

The temperature gauge of my 63 Eldorado does not work properly.

It goes slowly all the way up and stays there, while the true temperature is around 155-160 F (water in the radiator and/or the top of the thermostat housing).

Where should I start to solve the problem? The gauge itself, the temperature sensor, or the wiring? Or something else? The sensor is a new (aftermarket part) and the thermostat worked fine when I tested it in a saucepan. 

Many thanks

-Samu

Views: 373

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Jason Edge on October 26, 2023 at 5:24pm

I received my 5 sending units today and they are spot on in terms of expected resistance reading and operation in my 64 Coupe de Ville. The 4 extras will be for sale for $20 each ($15 for Chapter Members).  I also of course still have a good used one that came out of my car. Here are some pictures:

Comment by Jason Edge on October 23, 2023 at 8:30pm

That is good news, Bob. I ordered 5 and will do a comparison with the original I have in my car.

Jason. 

Comment by Robert Schles on October 23, 2023 at 5:11pm

It recently bought an ACDelco temp sensor from Rockauto https://www.rockauto.com/en/moreinfo.php?pk=343530&cc=1320309&a...

It is working like it should, reading the temperature correctly.  

Comment by Jason Edge on October 23, 2023 at 4:28pm

That is good news indeed. Now, if they would only start reproducing the correct replacements. The list if defective replacement parts is growing!

Comment by SK on October 23, 2023 at 3:24pm

Better late than never:

I finally plugged in the good used temp sensor bought from Jason, and the problem is solved.

The temp gauge stayed now at the lower 1/4 mark. The weather was allready quite cold (~35 degrees Fahrenheit), but with the previous sensor the gauge went up whatever the outside temperature was. 

That test drive was the last one for this season. Case closed and a good start for the garage season.

-Samu

Comment by Jason Edge on March 23, 2022 at 7:46pm

As Chris noted, most new temp sending units (at least the ones from China) are mis-calibrated and give a false hi reading. I have a good used sending unit that gives a resistance in the correct range I have seen for good sending units over the years for $20. I only have the one for now and the demand has been growing. I can ship to US destinations for $10 for a total of $30.  If you want it, shoot me an email to jasonedge@nc.rr.com.  

Comment by Chris Codd on March 23, 2022 at 3:14pm

I was just talking about this with Jason the other day as my car is doing the same thing. The new temperature sensors can be junk straight out the box. I believe Jason might have an extra used original one. I just ordered one from him yesterday. 

Photos

  • Add Photos
  • View All

Forum

63 Cadillac no electrical power

Started by David Erickson in General Discussion. Last reply by Dennis P. DiBari 11 hours ago. 1 Reply

I have a 63 cadillac park avenue.  My bulbs in the door panels in the front driver and passenger sides were out.  I replaced them today and no illumination.   My battery is fully charged and I tried…Continue

DIDGAKNOWTHAT? - Notches for Holding License Plate Door Open when "Filling Up!"

Started by Jason Edge in General Discussion. Last reply by Jason Edge 21 hours ago. 3 Replies

I casually mentioned during our Zoom meeting Sunday that there are notches for using the gas cap to hold the license plate door open while filling up and a couple of members indicated they did not…Continue

Hesitation on starting after driving

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Friday. 28 Replies

I have noticed that after I drive for 5-10 miles or more and then shut off the car, it hesitates when I go to start? Anyone experience this before and if so, what was the fix?Continue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Dave Fehrle on Friday. 12 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Blog Posts

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service