Wanted 1964 Sedan de Ville engine block
Dear all,
Looking for a good 1964 short block or complete 429 engine. Inner parts are not a must. Hope to hear your soonest reply. Thanks
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
I have a few 64 429 blocks to choose from. 200.00 plus the shipping.
email me at russ85747@hotmail.com
-
Permalink Reply by Clifford Muskus on
-
I'm interested in your generous offer Mr. Schillaci. Can I have an email address to discuss further details about the engine and shipment. Thanks
-
-
Don't post your email address on the internet. You will get more spam that way. Just click on Johns name and then in upper left part of his page click on the "Add friend" . After he accepted it use the "Send a message". Its a lot safer that way, for both of you.
-
-
Good information thanks Anders.
Members
Forum
Welcome Returning Member Maurice Hamelick from the Netherlands!
Started by Jason Edge in Chapter Discussion. Last reply by Maurice Hamelink yesterday. 2 Replies 1 Like
I wanted to give a shout out to returning Chapter Member Maurice Hamelick with his 1963 Four Window Sedan de Ville which was featured in our July 2016 Newsletter. Check out the newsletter via the…Continue
Rear suspension project
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 4 Replies 0 Likes
I have started my rear suspension project with the intent to replace bushings on the control links and yoke, shocks, coils and spherical joint. I have the car on jack stands and the transaxle…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Sunday. 3 Replies 0 Likes
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt May 20. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
