Does anyone have a working ‘64 Convertible top switch like the one pictured below that you would be willing to sell, or have a lead on where I can get one?  The new so-called “replacement” switch doesn’t fit the panel hole correctly nor the original mounting bracket. (And it looks different than the original! 😁).

Mike

Facebook Facebook

Views: 59

Reply to This

Replies to This Discussion

…or know of a place that can rebuild my switch?

Have you tested the switch with a continuity tester to confirm it is not working, and that your problem is not in wiring or elsewhere? These are pretty simple switches with contacts that bend down and make contact and close circuit when switch button is pushed one way or the other. Sometimes contacts just need to be cleaned or bent a little. Send it to me and  would be glad to repair for free.. you would just pay for shipping it back.

Hi Jason,

Thank you for the reply and kind offer to repair my switch.  
iThe problem is the switch, which I have been gingerly using for the past couple of years.  With the dash restoration and having to remove the switch.  When putting back in and testing on the circuit, it sparked and upon removal for inspection, a pin came out along with a small piece of the plastic casing. (I had one of the ugly 3 pin “reproduction” to test the circuit and it works just fine, except the new switch is hanging out of the hole; a temporary thing to get the top up and down). If you think with the broken pin it is still reparable, I will send it to you.  Btw there is a broken clip on it.  
Thank you again for your advice and repair offer.

Mike

I have the base and clips from other switches and should be able to repair yours. Let's say $10 for replacement parts. If interested in me repairing send to 
Jason Edge
104 New Rand Rd
Garner, NC 27529
Note I will be shutting down around this Friday for my trip to  Gettysburg and the GN so if I get it say by Wednesday I should be able to get it shipped out before I leave. 

Thank you, Jason.

I’ll get it out to you tomorrow, overnight. 

Mike

Good Morning, Jason,

I shipped the switch today by UPS 2nd day.  You should receive it by Wednesday.   Thank you, again.

Mike

Mike, The switch was received today and has been repaired. Check your email.
Jason. 

You are amazing!   Thank you.

Mike.

RSS

Photos

  • Add Photos
  • View All

Forum

Power steering fluid

Started by Bobby Brown in General Discussion. Last reply by Dennis P. DiBari 1 hour ago. 6 Replies

My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue

1963 AC evaporator core leaking?

Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kenneth Barton 20 hours ago. 2 Replies

Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue

Tags: 1963, core, evaporator, AC

seat foam replacement

Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Kevin Robles yesterday. 3 Replies

does anyone out there have any experience with seat foam replacement on  a 63/64 Cadillac.  I had my seats reupolstered  many years ago in original leather/fabric and they still look great, but the…Continue

1963 carter afb carbureter stainless steel shim

Started by tim sparks in General Discussion yesterday. 0 Replies

anybody have an xtra stainless steel shim for 1963 carter afb carb. thank youContinue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service