I am considering replacing the shocks in my 64 SDV. They're not terrible, but are a little too wishy-washy. I want to replace them with shocks that most closely approximate the original damping rate so that the original ride feel is not changed.

I am NOT after "handling" or anything that will firm up the ride -just as smooth a ride as was intended by our cars' manufacturer.

So, who likes what for this?

Thanks

Norm

Views: 44

Reply to This

Replies to This Discussion

I have been running and selling the Gabriel Gas Cushioned shocks as a good new replacement for at least 20 years now!  The front shock is 82109, and the rears are 82125.   They give excellent "shock absorption and dampening". The will of course not do anything to fix the support, or non-support rather, of 60+ year old coil springs. The only issue with he Gabriel shocks has been that the upper stud on the rears are a bit short to get both rubber bushing on, and you have to cut one thick bushing in halve, or find thinner bushings. I simply cut them in half. The set that are on my car now, again have been there I'm guessing 20 years. If I had driven the car harder or put more miles I might swap them out, but for now they  work great. 

I do keep a few sets on hand and sell these for $35 each to non-members, or $25 to Chapter Members.
You can also find them at various places online, but have not searched recently. If interested in a set email me. 

There are probably other good gas cushioned shock substituted but I have no experience with other brands.  Jason.

These Gabriel Gas shocks are excellent!  A great recommendation.

Dennis DiBari

Thanks, Dennis

Thanks, Jason. I will contact you privately

Norm

RSS

Photos

  • Add Photos
  • View All

Forum

Power Booster Install

Started by Rob Spring in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 4 hours ago. 5 Replies

Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue

Complete Front End Rebuild

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata on Thursday. 1 Reply

I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue

1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly

Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Wednesday. 1 Reply

Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering.  Also, possibly looking for an oil filter housing assembly for a 1964 429 motor.  Starting to get…Continue

A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies

As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 13 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service