Jason Edge's Discussions (2,267)

Discussions Replied To (1663) Replies Latest Activity

"Spray some WD40 around the insulator and it should gently pry out. At worse if it br…"

Jason Edge replied Dec 21, 2024 to Clock Removal

5 Dec 21, 2024
Reply by Jason Edge

"Dennis is correct on all accounts, especially about disconnecting battery. I will ad…"

Jason Edge replied Dec 17, 2024 to Clock Removal

5 Dec 21, 2024
Reply by Jason Edge

"Wayne, 4 things to consider on "sealing" the fasteners:1) I include bonded washers w…"

Jason Edge replied Dec 14, 2024 to Body side molding install help needed

10 Jan 7
Reply by Jason Edge

"They can be, but is not factory and is one of 3 attachment methods I recommend. I co…"

Jason Edge replied Dec 12, 2024 to Fender Trim Removal

6 Dec 12, 2024
Reply by Jason Edge

"From the factory the doors used the "bathtub" shaped push in fasteners for the inner…"

Jason Edge replied Dec 12, 2024 to Body side molding install help needed

10 Jan 7
Reply by Jason Edge

"On the rear qtr panel side trim for the sedan  You will have 5 push in spring clips…"

Jason Edge replied Dec 12, 2024 to Body side molding install help needed

10 Jan 7
Reply by Jason Edge

"See new eBay Listing for 1963/64 Cadillacs for December 11, 2024 below: 1964 Cadill…"

Jason Edge replied Dec 11, 2024 to Current 1963/64 Cadillac Listings on eBay

1 Dec 11, 2024
Reply by Jason Edge

"Some of you that go way back with the Chapter may remember some of these "coil sprin…"

Jason Edge replied Dec 6, 2024 to What To Do With Those Damn Coil Springs?!

4 Dec 7, 2024
Reply by Dennis P. DiBari

"Cool! I had forgotten about those playground spring rides. That would definitely be…"

Jason Edge replied Dec 6, 2024 to What To Do With Those Damn Coil Springs?!

4 Dec 7, 2024
Reply by Dennis P. DiBari

"See new eBay Listing for 1963/64 Cadillacs for December 4, 2024 below:   1963 Cadil…"

Jason Edge replied Dec 4, 2024 to Current 1963/64 Cadillac Listings on eBay

1 Dec 11, 2024
Reply by Jason Edge

RSS

Photos

  • Add Photos
  • View All

Forum

Power Booster Install

Started by Rob Spring in 1963/64 Cadillac Specific Discussion. Last reply by Rob Spring 3 minutes ago. 3 Replies

Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue

Complete Front End Rebuild

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata on Thursday. 1 Reply

I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue

1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly

Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Wednesday. 1 Reply

Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering.  Also, possibly looking for an oil filter housing assembly for a 1964 429 motor.  Starting to get…Continue

A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies

As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 13 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Events

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service