My power antenna motor operates in both directions, however the mast doesn't raise or lower, although I can do it manually. For the time being, I have disconnected the motor. I recall reading about a guy who replaces the unattached/broken cable in these units. The price was very reasonable, and I believe he was in TN somewhere. I'm also sure that the link to this person was on this website, but have been unable to find it.
I am thinking about placing this Caddy with a classic car consignment business, and I want everything to be working properly. I absolutely love the car, and have just ordered the correct green rubber OEM-style floor mats for it. Unfortunately, another unique Cadillac that I have been interested in for years just became available, but I have no room in my garage for both of them.
Tags:
Caddy Daddy has the replacement antennas.
Thanks Tony and Russ for your replies. Russ, I had already seen that Caddy Daddy has the replacement mast-only setup, but the accompanying you-tube video on how to mate it up with the rest of the unit is a little too complex for both my skill level and luck. They will do a total rebuild for $299, but I don't believe I need that, since the motor is still working properly, and the cosmetic repainting of the hidden unit is not important to me.
I know the person who just offered the service of replaced the broken or disconnected nylon cord was less $ than this, but I still can't find that resource, and I have checked other sites that I infrequently visit. I suspect that I will end up paying for more work than I actually need in order to get this fixed.
That video is showing a complete rebuild. If you buy a mast you don't need to rebuild everything, just remove the old broken mast and install the new. It winds in a cup adjacent to the motor.
The point being if you get a new Nylon cord installed on your old mast you will still have to mate it to your old motor assembly.
Just to add, if anyone IS doing a complete rebuild I do have a large set of mast tubes being cad plating for a like new appearance. Just one of the many items that I am having cad plated while I can.
HERE is the Caddy Daddy Link. I am surprised they don't want Carl Sagan money for it. $139 is not that bad. USA Parts sold them for $99.50 in 1995.
I can rebuild your antenna for 175.00 plus return shipping. The new mast will be installed and the gears will be lubed.
Just send me an email to; russ@thecadishack.com to get started.
Thank-you, Russ. My plan is to remove the assembly from the car today. When that is done, I will get in touch with you.
Travis J. Hensley Online
Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 7 hours ago. 13 Replies 0 Likes
My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue
Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion 9 hours ago. 0 Replies 0 Likes
Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue
Started by Bobby Brown in General Discussion. Last reply by Logan Robb 14 hours ago. 2 Replies 0 Likes
My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue
Started by Jason Edge in General Discussion. Last reply by Jason Edge on Saturday. 4 Replies 0 Likes
So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by