63/64 Cadillac Website

Cadmium Plated Cadillac Bolts - More Used that You Can Shake a Dip Stick At!

I have now had just under 3,500 lb of Cadillac fasteners gold cadmium plated, one thing I don't run out of or have to run down to the hardware store are nuts and bolts.

I just replaced my 20+ year old bench vice with another, and there was no running down to Lowe's or Home Depot to get the recommended 7/16" bolts! In fact I went with the Grade 5, TR stamped bolts and of course made sure I had a matched set.

For those of you that have followed may Cadmium Plated adventures, I thought you might get a kick out of the fact I actually use these fasteners for just about everything.

Check out my NC State Wolfpack Red Vice all blinged out with the Gold Cadmium Bolts:

0 members like this

▶ Reply to This

Welcome to
63/64 Cadillac Website

Sign Up
or Sign In

Or sign in with:

Photos

Forum

Trivia #33 - What % of 1963 Cadillacs Came with Limited Slip (Posi) Differential Rear End

Started by Jason Edge in Trivia 19 hours ago. 0 Replies 0 Likes

It has been way too long since we posted any trivia (and gave out a cigar), so here is one I thought I might have posted but do not see it: What % of 1963 Cadillacs came with the optional "Controlled…Continue

1963 Coupe de Ville Located in NC For Sale

Started by Jason Edge in For Sale. Last reply by Jason Edge yesterday. 2 Replies 0 Likes

I had an older couple contact me indicating they are selling their 1963 Coupe de Ville they have had for 40 years and they are located Moyock, NC, which is in the very north east part of North…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Thursday. 15 Replies 0 Likes

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Back to Basic Header, Lots of Cad to Sort, Etc.

Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes

I hope our US members had a great Thanksgiving and all members are ready for the holiday season. You probably noticed we went back to a more basic header on the website (in desktop mode). I had…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue