Recently, I was having some idle issues and found the vacuum at idle was very low. After testing everything I found the Idle Step Up Actuator had a leaking diaphragm. I contacted Daytona Parts to see if they had any, they didn't but said they could rebuild my actuator. I sent the actuator to them for the rebuild and was pleasantly surprised to receive it back looking like new. It looks great and holds vacuum with my MityVac. Hope it is pretty close to the proper adjustment when I get it installed.

Facebook Facebook

Views: 509

Reply to This

Replies to This Discussion

Looks fantastic.

Thanks Russ. For many years I've read on the CLC board how good these folks are. This is my first experience doing business with them, I'm very pleased with the outcome and transaction.

After posting the pictures, I installed the actuator. After dialing in the adjustment, it works as well as it looks!

Wow! That's a used part? Very nice work. Mind if I ask how much for the rebuild?

Clovis, Yes, it is the original part to the car. Rebuild including the return shipping was  $62. I'd say it's as close to new as you can get. 

Looks like new yellow/gold zinc coating too? Probably almost worth the price for that alone! 

Jason, they did refinish the part. It was a dull worn original finish when I mailed it off. The above 2010 picture shows what it looked like in the "before" condition.

I added Daytona Parts to our Parts Suppliers Page.

I'm going to check mine for leaks. Always good to get into that habit with our older cars.

RSS

Photos

  • Add Photos
  • View All

Forum

Wanted Cadillac Lasalle 2 inch Windshield Decal Sticker

Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari 18 hours ago. 3 Replies

for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Sunday. 2 Replies

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service