Clock Repair
Dear Jason,
Thanks to your site, my clock from my 64 Cadillac is now in Wisconsin being repaired with Clock Works. Finally, I'll have a working clock after many years.
Dennis DiBari
Replies to This Discussion
-
Permalink Reply by Jason Edge on
-
I have been dealing with Clock Works for 20+ years now and always a good experience.
-
Permalink Reply by Dennis P. DiBari on
-
Hi Tim,
Just got the clock returned to me from Clock Works in Wisconsin. With the battery disconnected, I intend to install it tomorrow hooking up the light and power clip. It looks like new and they had it for about 2-3 weeks. Looks like a very reputable company. The install on my 64 should not take long. Thanks to Jason and our chapter for more invaluable resources.
-
Permalink Reply by Russ Austin on
-
Thats where I get my clocks rebuilt, you will have no problems.
-
-
Thank you for the feedback, Russ. It is much appreciated!
Dennis DiBari
Members
Forum
Front door handle lights not working
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Wednesday. 3 Replies 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
4,442 Pounds of Cadillac Metal Cadmium Plated! - Pick-Up 12th batch Thursday
Started by Jason Edge in General Discussion. Last reply by Chris Codd on Wednesday. 1 Reply 0 Likes
Vintage Promo Picture #4 - 1963 Fleetwood 60 Special in Nevada Silver
Started by Jason Edge in 1963/64 Cadillac Specific Discussion on Wednesday. 0 Replies 0 Likes
Here is the 4th picture in my collection of "Promo Pictures" - another 1963 Fleetwood 60 Special. This 60 Special appears to be Nevada Silver, Paint Code 14. …Continue
lighted headlight switch
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf May 17. 2 Replies 1 Like
I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
