Greetings Everyone. I read a discussion thread about "radiator and related", covering coolant overflow. Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac? Is there if a particular universal reservoir that can be fitted and attached to the radiator support housing or the passenger inner fender? Then insert the overflow tube into the reservoir? Thoughts / suggestions?
I am monitoring coolant overflow and / or possible mixing with the oil. If an overflow reservoir doesn't clear up the puddle on the garage floor, I will investigate a possible head gasket issue.
Tags:
Several folks run the generic square coolant overflow tank. I see this in 99% of the uses. Amazon.com: Dorman 54002 Engine Coolant Recovery Kit Universal Fit ...
I mount mine on the RF inner fender right behind the radiator core support.
Thanks Russ. I'll check out the one you recommend.
Hi Michael,
I have a 64 Series 62 and albeit it never had an overflow for coolant, I decided to install one for safe measure. I found one that fit perfectly between the grill and the metal frame. Only had to drill one hole (the other was there) and it works perfectly. My email is ddibari56@gmail.com and can give you a picture and details.
Dennis DiBari, Cottekill NY
Michael,
I sent you an email with the information you requested.
Dennis DiBari
Hi Mike,
Any luck with the coolant overflow tank we talked about for your Caddy?
Dennis DiBari
Started by Rob Spring in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata yesterday. 1 Reply 0 Likes
I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue
Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering. Also, possibly looking for an oil filter housing assembly for a 1964 429 motor. Starting to get…Continue
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies 0 Likes
As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue
Posted by Chase on March 12, 2025 at 2:05pm 13 Comments 0 Likes
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2025 Created by Jason Edge.
Powered by