Anyone ever experienced the emergency brake pedal not locking in the "engaged" position. My pedal just springs back up - it won't lock when I press it. Everything else works, meaning the brakes engage, the pedal just won't stay down.

Facebook Facebook

Views: 452

Reply to This

Replies to This Discussion

Is that the case with the engine off? As you may know, the parking brake has a vacuum release that automatically releases the brake when it is not in Park or Neutral. The vacuum line comes from the Neutral safety switch. That said, the release mechanism could be malfunctioning. There is a manual release lever on the parking brake (push forward). You'll have to lay on the floor of the car to check everything out. It may just need to be lubed.

I pressed the pedal down this morning with the engine off and it stayed engaged. Once I started the car and put it in gear the E-brake popped up as it should. I just can't keep it engaged while thew car is running and parked for some reason.

A simple neutral safety switch adjustment may correct the issue. The adjustment procedure is in the shop manual (hopefully you have one). Not a terribly difficult job but you will be laying on the floor of the car reaching upward. You may want to remove the switch and clean and lube it. They do get brittle and crack as they age (like all of us do : ) There are a couple of Help topics on the NSS from the drop-down menu in the header of this page:

Tony is correct when he says "You can use the parking brake as an emergency brake—- if the brakes should fail and you push your foot on the parking brakes peddle ——to stop the car in a brake failure emergency." It serves as both a "park" brake and an emergency brake"

In fact it is stated right there in your owners manual:  "Since the parking brake is always released when the transmission selector is in "Drive", "Low" and "Reverse" ranges, it may also be used as a fully controllable brake pedal, providing rear wheel braking only, under emergency or special conditions."

Thanks guys. Yeah, should have referred to it as the parking brake. Yep, when I first got the car the brakes didn't work so driving the car on and off the trailer I used the parking brake to stop the car. Once I rebuilt the brake system and had the car on the road the parking brake worked fine. It was just in the last few months that it failed to engage, and it's just something I figured I would try to fix.

Anders. Lighten up.  Many of us on this side of the pond refer to Park Brake and Emergency Brake meaning the same thing... that "other" brake we need when we get in a tight spot when a good oak tree isn't available .... for sudden stopping or parked stopping. :-) 

RSS

Photos

  • Add Photos
  • View All

Forum

Logans Intake Project, 1964 Fleetwood, Progress Report #1

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 16 hours ago. 4 Replies

I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue

Rear main seal

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Phillip Hill yesterday. 4 Replies

Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue

1963 Cadillac differential 3.25

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Thursday. 2 Replies

I have a 1963 Cadillac differential with 80K on it. Found a limited slip a while back, and I do not think I will ever used the original diff.  In is in carlsbad California 92009.  Let me know if you…Continue

headlight / dimmer switch confusion (63 Sedan Deville)

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Thursday. 3 Replies

The schematics are from the repair manual and show a LIGHT BLUE wire coming from the headlight switch to the dimmer switch. From the dimmer switch to the low beams on a TAN wire and to the high beams…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service