To those that have rebuilt their engines:

To start, my 64 Fleetwood does not need an engine rebuild at this time. But eventually, it would certainly be nice. And I wonder, would it be more cost effective and efficient to have a complete secondary engine to rebuild in my free time and as funds allow? Then when ready, pull the old motor and put in the rebuilt one? 

To me, that sounds like a sure fire way to not rush things and make sure everything with the rebuilt motor is correct before dropping it into the car.

Just curious on everyone’s thoughts, thanks! 

Logan

Facebook Facebook

Views: 92

Reply to This

Replies to This Discussion

If you don't care about having the original engine in your car, then it's an okay plan. Keeps the down-time to a minimum.  

But, then you'll have one needs-a-rebuild engine left over. Do you have the room to store it?  I sure don't. 

And why would you want to keep the old engine?  With the newly rebuilt engine in the car, unless you put a rod through the block it'll probably go 80,000+ miles without needing another rebuild.  

My first question is worth addressing: "Is having the original engine of value to you?"  Answering that will make the rest of the decisions easier. 

Since it can take up to 4-5 months to get an engine rebuilt, it does seem like a good idea to have a spare engine. Just be sure that the engine can be run before being handed over to you. Not having the original engine really isn't a big deal. the VIN is stamped on the engine, so just keep the original engine or block.  

RSS

Photos

  • Add Photos
  • View All

Forum

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Dave Fehrle 3 hours ago. 1 Reply

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 17 hours ago. 8 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Getting hot when going fast…

Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 6 Replies

So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue

Rainstorm out of nowhere!

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply

After dinner last night, we went for a quick cruise as the weather was cooler and the sun set was looking really good!Out of nowhere, a pop up shower appeared overhead and down-poured as we were…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service