I have a question about the padding  used between the  headliner and  interior roof of hardtops . It's abt 1/8" thick and  I  want to remove this from my parts car because I use it for storage ; with the headliner badly torn , it's making a mess.  I figure with the  period these cars were built , possibility  of asbestos  exists . If so, I'll probably  just use a roller and paint over it . Comments?

Facebook Facebook

Views: 153

Reply to This

Replies to This Discussion

If the headliner is no good and just using for storage I would rip out the headliner, rip out the insulation, and remove the listing wires (thin rods that run from side to side that support the headliner) and # them front to rear if you plan to reuse. That insulation is very flammable and is a mess once it starts coming a part and don't mess around with it and trash it and save the listing wires from all of my parts cars. Some body styles, and depending on production date, had removable center roof bows. I will also remove those. If they are welded in place I usually leave them for the metal yard..  If you plan to replace the headliner with original or something similar be sure to save a good sample of it. Be sure to also note the trim code on the body plate on top of cowl. I usually save mine in an air tight bag and note the body style and trim code. 

 Thanks Jason,   yes , I want to just get rid of the headliner and  padding , it's  never gonna be on the road again. Until I can find out about possible asbestos , this project's on hold ; I'll move onto something else. Guess I could wear a filter mask , but afraid I'd start a  PANIC!

Not sure.. I've ripped 51 of them out, no mask and still here.  If concerned I would wear the mask. It doesn't take but a few minutes to get it out and if you think it does have any carcinogens, it is probably going to do you more long term damage if it just remains there above your head especially if it is already coming apart and out.

Thanks again, Jason. A very valid point indeed !  Yeah, I'll just wear a filter mask, I can just explain if the county health dept  shows up ; only half kidding! The people around here, Jeesh!

RSS

Photos

  • Add Photos
  • View All

Forum

Wanted Cadillac Lasalle 2 inch Windshield Decal Sticker

Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari yesterday. 3 Replies

for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service