I have an issue with my left side lower bulb in the bumper end housing portion. The bulb that operates the backup light. I can't get a bulb to operate although I do get 12V when I put my tester to that center pin inside the bulb housing. I even added some solder to the tip of the bulb contact to see if the buidup would help contact, but no go. The bulb does take a bit of effort to insert as if it is contacting the spring loaded pin.
Dan
Tags:
U had this same issue and messed with the socket for a long time, but could not get it to work consistently - the spring at the base was just too old and had lost its springiness. I replaced the socket and all was well. I documented the process at the link below - it is really pretty easy and actually took much less time than I had spent fiddling with the original socket.
http://6364cadillac.ning.com/forum/topics/1963-tailight-backup-ligh...
Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari yesterday. 1 Reply 0 Likes
for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies 0 Likes
Is anyone here planning on going to the Back to the 50’s car show in Minnesota?
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Sunday. 2 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
June 22, 2025 from 8pm to 9:30pm – Zoom
0 Comments 1 Like
© 2025 Created by Jason Edge.
Powered by