We were discussing octane earlier. Note the (R + M)/2 you see on pumps in U.S. This average of the RON & MON ratings is also called the PON rating referenced earlier where I stated:
In your 1964 Owner Manual on page 36 it indicates to use Minimum of 100 octane RON, or 89 octane MON. If you do the math to get the PON # that comes out to 94.5. So..that means the 93 Octane Premium in the US (PON) and the 99 Premium in the UK (RON) are both just tad lower than the recommended minimum octane for our 10.5 to 1 compression engines. My 64 CDV runs fine on 93 Octane, however, adding octane booster seems to give it more power. Keep in mind that the 94.5 would be a minimum recommendation and not an average or maximum recommendation.

Facebook Facebook

Views: 321

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Che Gallagher on February 11, 2022 at 5:52pm
Thanks for all the comments it has definitely been helpful i now have a good knowledge of how it all works and what i need to do. Thaks everyone
Comment by Michael Vogler on February 8, 2022 at 9:56pm

The lead in gasoline helped reduce engine knock and acted as a lubricant on the valve guides in these old engines.    

I was told by mechanics on each of my vintage cars (two '65 Mustangs and two '64 DeVilles) that running the car without the lead additive may, over time, damage the valves, resulting in an upper engine rebuild (unless the engine was rebuilt with modern stuff). 

I always put in the highest octane gas I can find and lead additive when I fill up.  Certainly doesn't hurt.   

Mike

Comment by Che Gallagher on February 7, 2022 at 6:30pm
With the 429 engine can you just run it on a unleaded or do you have to add a lead additive to it
Comment by Jason Edge on September 2, 2012 at 9:22pm

I'm not sure how much lead additives raise the octane (if any). These higher compression engines were made for higher octane gas than the 80 something regular stuff they sell now. There is a lot of information on octane and engine compression out on the web. The best my car ever run (well before I rebuilt the engine) was on a strong dose of the 100+ octane AV Gas. I can remember here in NC growing up in the late 60's and early 70's where Hi Test was 95 to 98 octane and 93 would be more or less mid-grade.  The diffference was there were still many high compression engines on the road and being produced and the low compression 9.0 to 1, 8.5 to 1 and lower compression engines were just starting to replace these older high compression cars.  The new cars with low compression engines and electronic ignition that can automatically adjust timing as needed can burn the low octane stuff but I would never recommend putting regular in a 10.5 to 1 compression 390 or 429. 

Comment by Jason Edge on September 2, 2012 at 2:54pm

tagged as octane, octane rating, and fuel rating and set-up URL http://6364cadillac.ning.com/photo/octane for easy reference.

Photos

  • Add Photos
  • View All

Forum

Wanted Cadillac Lasalle 2 inch Windshield Deca;\l Sticker

Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari 9 hours ago. 1 Reply

for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Sunday. 2 Replies

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth on Saturday. 15 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service