63/64 Cadillac Website

side marker w script

I 3D printed a Cadillac script for my cornering light which has been also modified to work as a side marker.

1 member likes this

Facebook Facebook

View Full Size

Tags:

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Dennis P. DiBari on May 21, 2025 at 6:34pm: Kurt,

I love your cornering lights and lens script on your Caddy!!!!!!

Dennis DiBari

Comment by Bill Wolf on May 21, 2025 at 4:41pm: That looks great. I like the font.

Comment by Kurt on November 27, 2023 at 5:54pm: Thanks for the comments. It is just PLA plasic. 3D printing is a fun hobby. Would love to have a 3D printer that prints in metal but that is unlikely due to the cost. I haven't considered metal casting but might look into that.

Comment by Roy Brosi on November 27, 2023 at 12:28pm: Looks great! Like it should have been there all along.

Comment by Jason Edge on November 23, 2023 at 8:27am: Very cool! That looks a lot like the 63 dash script.

Welcome to
63/64 Cadillac Website

Sign Up
or Sign In

Or sign in with:

Photos

Members

View All

Forum

seat foam replacement

Started by Kevin Robles in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 1 hour ago. 1 Reply 0 Likes

does anyone out there have any experience with seat foam replacement on a 63/64 Cadillac. I had my seats reupolstered many years ago in original leather/fabric and they still look great, but the…Continue

1963 carter afb carbureter stainless steel shim

Started by tim sparks in General Discussion 2 hours ago. 0 Replies 0 Likes

anybody have an xtra stainless steel shim for 1963 carter afb carb. thank youContinue

Timing cover corrosion

Started by CHRIS CARLSON in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari 10 hours ago. 1 Reply 0 Likes

Hey fellas if you're rebuilding your 429 check your timing cover for corrosion behind the water pump Russ and I had 429 engine number two on the dyno today had shimed the oil pump spring for a…Continue

Convertible bumper jack

Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 17 hours ago. 13 Replies 0 Likes

My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk. Anyone have a picture of the item I should find?Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue