Jason, I liked the detail and information you have provided. I would like to do mine similar to yours. Can you help? Do you have trunk material? OPGI is sending the trunk product for my 63 Fleetwood. But it does cover the entire trunk as yours was done. If you do not have can you give me a reference? Thanks!! Bob

Views: 200

Comment

You need to be a member of 63/64 Cadillac Website to add comments!

Join 63/64 Cadillac Website

Comment by Karl Schwarz on May 10, 2021 at 2:13pm

I used mostly Gorilla Glue Spray Adhesive. I also used some 3M spray adhesive (I think #77) that I had half a can of. Both worked fine and gave me time to position and reposition fabrics while also being secure once dry.

Also, I reused the backing of the piece that comes down from the back shelf, but replaced the backing on the back (taillight end) of the trunk. For the replacement backing I used Neoprene Sponge Foam Rubber that I also got on Amazon. One 15" x 60" roll of this material was just the right amount.

Comment by Karl Schwarz on May 10, 2021 at 1:29pm

I just redid my trunk. SMS Auto Fabrics sent me a sample of their fabric (about 1 1" square) and it looks essentially identical to the original fabric. I think the cost is $89/yard. It also seems to be directional (meaning it will look weird if the weave pattern is not oriented to make the weaves all go in the same direction) which will likely increase the amount of fabric needed. I don't really like the original material, and did not want to spend a lot the trunk, so I purchased my material on Amazon. I think it is similar to what OPGI sells (which is not a match to the original). The fabric I used can be found here for $60. I ordered one 4' x 20' piece that was just enough (it came as two 4' x 10' pieces). I was very happy with my choice.

You can see before, in progress, and after pictures of my trunk restoration....

Here is the end result before I put the jack and spare back in.

Comment by Jason Edge on April 9, 2021 at 2:53pm
SMS Auto Fabrics (www.smsautofabrics.com) sells the original fabric used on the trunk mat, rear walls, wheel well corners and back hump (and used on all cardboard sides for the Fleetwood and Eldorados. ) You will need about 3 yards as I recall for body styles other than the Fleetwood & Eldo.

Photos

  • Add Photos
  • View All

Forum

windshield wiper/washer issue

Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge 7 hours ago. 9 Replies

I have a 64 Cadillac Deville convertible. When the wiper switch is turned on the washer pump activates continuosly no mater what speed is selected. Washer pump shuts off when wiper switch shut off.…Continue

T-3 headlights for sale

Started by Russ Austin in For Sale. Last reply by Russ Austin 8 hours ago. 2 Replies

I have 2 working T-3 low beam headlights and numerous T-3 high beam headlights for sale. Low beams are 22 each  and high beams are 15.00 each plus shipping. Please email me at russ@thecadishack.com …Continue

cornering lights

Started by Larry Rees in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 19 Replies

Neither of my cornering lights are working. I started by focusing on drivers side. I removed the entire assembly and cleaned it up, replaced the wire to the socket, cleaned and lubricated the socket…Continue

My '64 Deville Radio Rebuilt and Upgraded.

Started by Michael Vogler in 1963/64 Cadillac Specific Discussion. Last reply by Tony Prichard yesterday. 7 Replies

My original '64 Devile radio has been rebuild and upgraded.  Can't wait to get in back in the car!https://youtu.be/DgYqoV290KwContinue

Blog Posts

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Vintage Air AC

Posted by Chase on March 21, 2024 at 5:55am 0 Comments

Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!

accumulator dryer

Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments

Who rebuilds original AC  accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year ,  There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A    What  is everyone using ? I would prefer to be as original as possible. Thanks

'63 Eldorado trumpet horn + 2 standard horns restoration

Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment

My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns. 

There is a restoration service called The Horn Works who my son…

Continue

Videos

  • Add Videos
  • View All

© 2024   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service