My Eldorado has bucket seats.  The controls lack tilt.  Is this how they came? 

ithe door mounted control knob has forward/back and up/down but, no tilt.  
the up down isn’t working at the moment and forward/back is sluggish and pulls more from one side of the tracks.  

Facebook Facebook

Views: 114

Reply to This

Replies to This Discussion

They came with 4 way (up, down, forward, back) on the driver side, and 2 way (forward and back on the right side).  If you want them to tilt back you can always unbolt front and add some rubber blocks under the front.   

- For non movement check the transmission on the left driver side for dried grease. Unbolt driver seat, flip back, and remove the transmission, open the case, and remove all dried grease especially on the slide rods that the electromagnetic actuators engage to pull the gears together to make the seat cables spin. The grease dries up and prevents movement of the actuators. Click on Seat Transmission - Cleaning the 6-Way and 4-Way Seat Transmissions to go to our Help Page for a visual and more details on cleaning. 

- For slow movement, unbolt seat, flip back clean out the tracks with WD40, 0000 steel wool, compressed air and whatever you have to work with. Also check that the main ground wire is secured to the floor. It usually a thick blue wire with an round connector that goes under one of the seat rail to floor bolts. Give the bolt and extra snug and make sure it is tight.  Also makes sure seat left and right rails are in same relative position front to back. Simply measure from front or back for equal distance.  Motor could be tired and burning out but usually cleaning and greasing seat rails and checking that ground will do the trick. Also make sure the seat harness connectors at motor and transmission are making good contact. Pull apart and clean if unsure. 

Thank you for answering the question. 
I was just watching the online dealers information and trying to pause the slideshow on the Eldorado seat page.  

‘’I’ll copy down the repair details for action when time permits.  

RSS

Photos

  • Add Photos
  • View All

Forum

Convertible bumper jack

Started by Alan Clark in 1963/64 Cadillac Specific Discussion. Last reply by Alan Clark 23 hours ago. 4 Replies

My car lacks the mechanism or spring needed to hold the jack in the storage slot on the right side of the trunk.  Anyone have a picture of the item I should find?Continue

Wanted Cadillac Lasalle 2 inch Windshield Decal Sticker

Started by Doug Scarrow in Wanted to Buy. Last reply by Dennis P. DiBari on Saturday. 3 Replies

for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue

Back to the 50’s

Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe Jun 17. 2 Replies

Is anyone here planning on going to the Back to the 50’s car show in Minnesota?

where to find 1963 Cadillac Plastic Door Pin Anchors

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge Jun 15. 2 Replies

Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service