Hi
some more mysterious parts under the hood (or somewhere there?)
Part 1 is sheet metal bracket
Photo 2 include 2 different brackets
Photo 3 include 2 similar clamps
Tags:
I believe the clips in photo #3 hold the transmission fluid cooler lines that go to the bottom of the radiator.
Part 1 is a bracket for one of the cooler line clips in photo 3, the bracket is attached to one of the front oil pan studs. The right bracket in photo 2 could be the washer fitted between the starter bracket and the oil pan. I dont think the left bracket in photo 2 is a oem part.
/Jan
Pics have been mostly answered but I will chime in with more detail.
Picture 1: is the bracket mounted to stud at right front corner of oil pan for Trans Cooler lines as seen in Pic 3.
Picture 2 on left: is the strap that attached to RH trunk cardboard wall to hold the jack base in place (see pic below).
Picture 2 on right: is the 1964 Turbo Hydramatic Starter spacer that goes between the starter support bracket and the oil pan.
Picture 3 are the trans color line clamps... one mounts to that bracket in picture 1 on the U nut clip end and the other mounts to a U nut clip attached to the front trans inspection pan that goes in front of the adaptor ring.
Just to add, there is another similar looking clamp use on the rear facing front frame section for the gas line and the brake line but you can always tell it from the trans line clamps since it has a large back section for gas line and smaller front section for the brake line. The trans lines have the same size "humps" since the trans lines are the same diameter.
Thanks Jason! Excellent info and photos!
Started by Jason Edge in General Discussion 6 hours ago. 0 Replies 0 Likes
I have now had just under 3,500 lb of Cadillac fasteners gold cadmium plated, one thing I don't run out of or have to run down to the hardware store are nuts and bolts. I just replaced my 20+ year…Continue
Started by Scott Santora in General Discussion. Last reply by Dennis P. DiBari yesterday. 4 Replies 0 Likes
I could use some confirmation. I sent out my radiator for my 63 De Ville to get re-cored. Several weeks later, when I went to pick it up from the service vendor, I noticed a large amount of green…Continue
Started by Jason Edge in Trivia. Last reply by Cees de Bunje yesterday. 13 Replies 0 Likes
It has been a while since we did some trivia and I was watching a movie last night and saw this 1964 Coupe de Ville that briefly makes an appearance. The Trivia Question is: What Movie Is this?…Continue
Started by Todd Fox in Restoration Discussion. Last reply by Todd Fox on Wednesday. 2 Replies 0 Likes
Has anybody in here found a good supplier of replacement floor braces for the 64 convertibles. Continue
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 0 Likes
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 0 Likes
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
Posted by CHRIS CARLSON on December 6, 2023 at 10:54am 0 Comments 0 Likes
Who rebuilds original AC accumulator dryers for 1964 Cadillac? I have been on Classic auto air in Tampa FL wait list for over a year , There is one on Old air products web site that looks very similar to the original # 21-4214A but states it fits 1962 Gm cars, The one recommended for a 1964 Cadillac is half the length 21-4215A What is everyone using ? I would prefer to be as original as possible. Thanks
Posted by Les Eastling on November 15, 2023 at 10:34am 1 Comment 0 Likes
My son, unbeknownst to me, had all three of the horns on our 1963 Eldorado completely restored. We had recently added the Eldorado trumpet horn to the two standard horns and the sound was not very good... we had heard good ones so we knew something was not right... but there was not much we could do to get better sound from the 3 horns.
There is a restoration service called The Horn Works who my son…
ContinueApril 21, 2024 from 8pm to 9:30pm – Zoom
0 Comments 1 Like© 2024 Created by Jason Edge. Powered by