I would appreciate any info where to put those loose padding pieces under the carpet. 4  big ones are quite simple but how about those smaller triangular parts?

and where shall those long black pieces go? They are like carton with some kind of treatment

Views: 214

Reply to This

Replies to This Discussion

The padding is just to level the floor off. The metal pan is full of dips and grooves, so just fill them in to make the floor level. 

If this is original padding I would toss it and get some newer aftermarket fire resistant padding. I know of more than one car where the exhaust caught this stuff on fire where it burned the exposed padding under the driver side where floor board was compromised. I actually use this stuff as fire starter in my old cook house! While I like staying original as I can, there is much better material out there now that is fire resistant and provide better sound proofing.  

Thanks for good reminder! I plan to put some sound deadening material to floor to resist heat as well.

Two long pieces go under the rear seat where is no carpet. Pieces have holes in place where rear seat belts are attached.

Padding pieces found their own places. They level the floor off like Russ mentioned.

Is there another material you guy think these leveling panels could be made of? Getting ready to put new carpet in and I dont have these panels anymore. Body shop threw them away

RSS

Photos

  • Add Photos
  • View All

Forum

Burning Rubber

Started by Kim K Kaiser in 1963/64 Cadillac Specific Discussion. Last reply by Kurt 3 hours ago. 7 Replies

Out of curiosity,, is the 63 64 engine capable of burning rubber off of a stop light?   Not a hold the brake and rev up and release, but from a stop, to burn rubber power?I know mine wont because i…Continue

Gas gauge only reads half when full

Started by Kenneth Barton in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Wednesday. 1 Reply

Hi everyone, I installed a new gas tank sender in my 63 after bench testing it and confirming ohm range on the bench.However after installing and filling it up, it only reads half full after filling…Continue

64 Brakes

Started by Jeff Donaldson in General Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply

Hi,It's time to do a brake job on my Fleetwood. When I imported my car from the US to Canada I had to have my car safety inspected before I could license it in the Privince of BC. After the…Continue

Heater Core Replacement

Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson Feb 15. 6 Replies

I'm currently rounding up parts for a heater core replacement in my 1964 Deville.  I'm looking for replacement hoses that connect to the heater core itself.  It's a factory a/c car and has the metal…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2026   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service