The temperature gauge of my 63 Eldorado does not work properly.
It goes slowly all the way up and stays there, while the true temperature is around 155-160 F (water in the radiator and/or the top of the thermostat housing).
Where should I start to solve the problem? The gauge itself, the temperature sensor, or the wiring? Or something else? The sensor is a new (aftermarket part) and the thermostat worked fine when I tested it in a saucepan.
Many thanks
-Samu
Comment
That is good news, Bob. I ordered 5 and will do a comparison with the original I have in my car.
Jason.
It recently bought an ACDelco temp sensor from Rockauto https://www.rockauto.com/en/moreinfo.php?pk=343530&cc=1320309&a...
It is working like it should, reading the temperature correctly.
That is good news indeed. Now, if they would only start reproducing the correct replacements. The list if defective replacement parts is growing!
Better late than never:
I finally plugged in the good used temp sensor bought from Jason, and the problem is solved.
The temp gauge stayed now at the lower 1/4 mark. The weather was allready quite cold (~35 degrees Fahrenheit), but with the previous sensor the gauge went up whatever the outside temperature was.
That test drive was the last one for this season. Case closed and a good start for the garage season.
-Samu
As Chris noted, most new temp sending units (at least the ones from China) are mis-calibrated and give a false hi reading. I have a good used sending unit that gives a resistance in the correct range I have seen for good sending units over the years for $20. I only have the one for now and the demand has been growing. I can ship to US destinations for $10 for a total of $30. If you want it, shoot me an email to jasonedge@nc.rr.com.
I was just talking about this with Jason the other day as my car is doing the same thing. The new temperature sensors can be junk straight out the box. I believe Jason might have an extra used original one. I just ordered one from him yesterday.
Started by Michael Monson in Wanted to Buy 6 hours ago. 0 Replies 0 Likes
Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering. Also, possibly looking for an oil filter housing assembly for a 1964 429 motor. Starting to get…Continue
Started by Jason Edge in General Discussion. Last reply by Jason Edge 7 hours ago. 1 Reply 0 Likes
As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue
Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Kurt 9 hours ago. 1 Reply 0 Likes
Hi all,Again I have issues with my AC system. Had it refilled recently but within a few days the system was empty again. The AC mechanic added tracer fluid to check for leaks, but there are no…Continue
Tags: 1963, core, evaporator, AC
Started by Karl Schwarz in 1963/64 Cadillac Specific Discussion 10 hours ago. 0 Replies 0 Likes
I have a 1963 Series 62 convertible that I'm going to have the interior redone on. The car is Matador Red with a black interior. I'm looking to make the interior pop a little more than it does with…Continue
Posted by Chase on March 12, 2025 at 2:05pm 13 Comments 0 Likes
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2025 Created by Jason Edge.
Powered by
You need to be a member of 63/64 Cadillac Website to add comments!
Join 63/64 Cadillac Website