Blower Motor 1964 Fleetwood
My blower motor has bitten the dust. It works but makes a horrible squealing noise. I like having AC, but its deafening and probably not worth tearing something else up to have it.
A previous owner cut an access port in the top of the blower housing and I tried soaking the motor first with brake clean to clear any debris and then shot some WD in there hoping it would make its way to the bearings. I don't think that worked, after about 20 min, it was still squealing.
So I then proceeded to attempt to take the blower motor out after referencing the page and found it could be done without hood removal and just dropping the motor and nothing else. WELL, let me tell you, if you are able to get the blower motor out from the top you are a master mechanic. There is not a shot in hell that blower motor is coming out from the top. MAYBE from the bottom, but I'd imagine that I'd have better luck removing the access panel in the wheel well.
So, a few questions-Is the motor greaseable in any way INSIDE the car w/o removal? Second, how big of a job all together is it to replace the blower motor. I see some online for like $100 and think that may be my best bet to get a reliable fan.
The weather here in C Illinois is still decent with no air, but come late June, I'm going to be BEGGING for air.
Any tips and tricks are certainly appreciated!
Logan
Replies to This Discussion
-
Permalink Reply by 3ft7bqmb7dryo on
-
Take the inner fender access panel off. The blower motor is not serviceable, just swap out the blower case and scrap it.
-
Permalink Reply by Logan Robb on
-
I am seeing all kinds of results online for the blower motor-any suggestions on a replacement? Looks like this motor may have been used frequently across the GM line...
Logan
-
Permalink Reply by Jason Edge on
-
If you have a problem getting a correct new motor, I have a bin full of used, tested, originals that blow hard and quiet and includes the fan cage for $40 ($30 after Chapter discount).
-
-
I should have checked with you first, I don’t know why I didn’t even think of that!
I have one ordered that I put in with my most recent RockAuto order-so we shall see if this is the correct one
-
-
It i a typical GM blower motor. You will find that the vent hole for the rubber tube is in the wrong area, or not there at all.
Photos
Members
Forum
Power Booster Install
Started by Rob Spring in 1963/64 Cadillac Specific Discussion. Last reply by Rob Spring on Tuesday. 9 Replies 0 Likes
Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue
1964 Cadillac Deville Neutral Safety switch and Oil Filter Housing Assembly
Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Monday. 3 Replies 1 Like
Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering. Also, possibly looking for an oil filter housing assembly for a 1964 429 motor. Starting to get…Continue
Complete Front End Rebuild
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata Apr 3. 1 Reply 0 Likes
I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue
A Shout Out to Alan Grist & Some Pictures of His 1964 Series 62 4W Sedan
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari Apr 2. 2 Replies 0 Likes
As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 13 Comments 0 Likes
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
