Gentlemen,

In the last week or two, I've been noticing that when pulling up to stop light (low RPM) my headlights dim slightly, as do the instrument panel lights.   I suspected that I should replace my voltage regulator, which I did today.  15 minute job.  No big deal.

However, when I started the car, at idle, the GEN light came on and stayed on until I pressed on the accelerator just a bit and the GEN light went off, and stayed off as I drove the car.  

As I approached a stop light, when the RMPs dropped off, the GEN light came on again.  When the light changed and I started to accelerate, the GEN light went off.  The cycle repeated itself.

So, because the wife doesn't know how look it takes to change the voltage regulator :-D, I drove over to the nearby auto parts store, bought a new alternator (I figured because why not..perhaps the old one was beginning to fail), and installed a new one.

When I started the car, the same thing with the GEN light continued:  idle = GEN light.  increasing the RPMs = NO GEN light.    And, it appears the headlights at low RPM dim even more than before I changed the Voltage Regulator and the alternator.   UGG!

I checked the ground on the voltage regulator and the ground appears to be solid.

The only thing I did not change in this circuit was what appears to be a variable resistor of some sort??? See below with the ARROW.  

Any thoughts about what might be going on????  Could it be that the new voltage regulator I installed is bad?

Michael

Facebook Facebook

Views: 257

Reply to This

Replies to This Discussion

Here it is with the new voltage regulator.   As I consider (obsess) this problem, it seems to me it either has to be this, the ground, or a bad voltage regulator, no?

Here’s a video of the problem.  Also, should ‘t the GEN light be on when the ignition key is in the ACC (eg radio only) position?https://youtube.com/shorts/8l7K_IuMIAA?feature=share

Thanks Mark.   I’ll give it a shot.

I put the old voltage regulator back on and the GEN light has gone off and I’m no longer having the problem.  Go figure.

i’m certain I need a new voltage regulator as the head lights are flickering and dimming slightly at low RPM.

I inspected the black ground wire from the alternator to the voltage regulator and it’s old and the plastic coating broken in several place.  I was considering running a new ground wire and trying out the new voltage regulator again. 
Of course, I could throw in the towel and take the car into my mechanic, but what’s the fun in that?

RSS

Photos

  • Add Photos
  • View All

Forum

Power steering fluid

Started by Bobby Brown in General Discussion. Last reply by Dennis P. DiBari 7 hours ago. 1 Reply

My reservoir is a little low. Any recommendations on my purchase of refill fluid? There are likely new fluids and I’d like to buy the right product. Thanks. Continue

Dino Diaries - July 11, 2025 - Busted!

Started by Jason Edge in General Discussion. Last reply by Jason Edge on Saturday. 4 Replies

So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Thursday. 3 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service