Ok so I started by following the instructions in the shop manual and came to the part where it says remove 2 screws that attach the panel to the dash. I can't seem to find the 2 screws. has anyone ever done it without removing the cluster assembly?
Tags:
I asked myself last night after 3 hrs of going nuts. How bad do you need this to work? Just roll down the windows you have 8 to open and they are all power. are you nuts you live in the Midwest not the dessert. I can see where someone needed to save me from myself and quit and decide I would see what everyone had to say today. Well as I thought and see from all the comments. it's one big cluster F**** mess and I am into deep now to quit and will have a big smile on my face when it hits the 90's here and when at the shows and someone asks does the Air work and I can say yes Thank you all for the input and stand by as I may need a unit if someone has one and also I have to look but may need some dash bulb sockets as someone went thru here and broke a few sockets and ripped the wires from them Knew my Dash didn't light up right at night Thanks again all
Whereabouts in the Midwest Raymond?
Northwest suburbs of Chicago town called Roselle
After I asked the question, i noticed on your profile page where you were.
My wife and I will be in Illinois in 5 months time, but we won't make it over to your part of the state..... at least, I don't think we will, unless we're lost.
If ya see a rental car cruising around ya neighborhood with a couple of lost Aussies in it, ya might have to whack the jug on.
Remove the dash pad and headlight switch. It's then a ten minute removal. I've had mine in and out twice. It will come out the top of the dash with a couple of maneuvers. The dash and switch also come off pretty easy. On the 64's you just have to watch where you put your hand removing the dash or you will crush the in dash sensor.
Our 64 Fleetwood had suffered a similar short in the A/C at some point before we got it as well.
Our fuse box took a heap of heat through it too, so it would be wise to suss that out closely. My sparky was surprised our car hadn't burnt to the ground from it.
We now run, a brand new fuse box that accepts those plug in fuses.
I also run a fusable link at the battery as a safety exercise.
Mine had the same issue at some point in its life. Burnt on/off switch, damaged fuse box and even melted ignition switch socket. I went through my electrical system and replaced all of that when I restored my interior, and will be installing a fusible link at the starter (where all the power is sourced) like later 60's cars did. Hopefully that will prevent it from happening again.
I have a fan switch. Please email me at; russ85747@hotmail.com Include your zip code for a shipping quote.
Started by Frank Murch in 1963/64 Cadillac Specific Discussion 12 hours ago. 0 Replies 0 Likes
I have a 1963 Cadillac A/C car differential. It is low miles and not a limited slip. I switch to a LSD but have this nice piece for several years. It is in San Diego, If interested let me know…Continue
Started by Donald Swenson in 1963/64 Cadillac Specific Discussion. Last reply by Donald Swenson on Saturday. 2 Replies 0 Likes
Hello,Just wondering if anyone has photos to where I need to apply new SEM seam sealer on the front of the fenders to the inner top Cowl area and the corners of the Radiator support?I am in the…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb on Saturday. 2 Replies 0 Likes
I was watching a YouTube video (I'll attach it below) of a 1964 Fleetwood 60 Special revival and I noticed it was equipped with a rear defrost option (as well as nearly every other option for 1964…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb on Saturday. 8 Replies 0 Likes
The wintertime blues are hitting hard as 3-6" of snow is forecasted for later this week. Share your favorite photos of your 63 or 64 Cadillacs! Spring/Summer/Fall cant get here soon enough!Thanks for…Continue
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Posted by Chase on March 21, 2024 at 5:55am 0 Comments 1 Like
Hey everyone, has anybody done a Vintage Air AC/Heat setup in their car? I want to bypass the old vacuum setup and go with a Vintage Air Gen 2 model. Before I get started, does anyone have any experience with this? (Which model to go with, do’s and dont’s, etc.) It looks pretty involved. Any and all info/pics would be greatly appreciated. Thanks!
February 23, 2025 from 7pm to 8:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by