1963 transmission dipstick tube came out
I went to check the fluid in the transmission on my 1963 Series 62 convertible and when I pulled on the dipstick ring the whole tube came out. I got it back in the hole, sort of, but it is loose. Anyone else have similar issue and any tips on how to get it seated back in tight? I don't have a lift or an easy way to lift the car and safely get under it.
Replies to This Discussion
-
Permalink Reply by Kurt on
-
The oil dipstick tube bolts to the passenger side exhaust manifold. Did you see a metal tab on the tube with a bolt hole it in it?? If not, it may have broken off. There is also an o-ring inside the the transmission housing where the dipstick tube is inserted. If the o-ring is bad or missing and the tube is not bolted in properly, the transmission will leak like a sieve when the car is parked. Been there, done that.
Members
Forum
Commercial Chassis Dual Battery Tray Questions
Started by Michael Monson in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge yesterday. 2 Replies 0 Likes
I'm looking for some info and hopefully some pictures on the commercial chassis dual battery setup. Is the second battery tray (driver side) , the same as the passenger side or is it mirrored? I'm…Continue
Meet-Up of 1964 Cadillacs in downtown El Segundo Car Show August 16
Started by Jason Edge in Chapter Discussion yesterday. 0 Replies 0 Likes
Chapter member Alan Clark and owner of a 1964 Eldorado sent this and wanted to share with everyone in case there are others nearby that might want to attend:"I'd like to invite the 63/64 chapter…Continue
The $120,000 1963 Eldorado on Bring a Trailer
Started by Jason Edge in General Discussion. Last reply by Jason Edge on Friday. 7 Replies 0 Likes
I have got a flood of email, texts, about the 63 Eldo that recently bid up to $120,000 and thought I would share for those that have not seen it.Here is the link:…Continue
Fuel Supply System - Check Points Beyond the Fuel Pump
Started by Jason Edge in General Discussion Aug 6. 0 Replies 0 Likes
Incredibly, in 3 days I have had 3 people ask about replacing their fuel pump or even adding an electric fuel pump because there carb is not getting gas. It has gotten to the point I have copied and…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
