When I purchased my 64 Fleetwood, one of the letters on the drivers side was missing, buy the time I drove it over 200 miles home, I had lost another letter. Now, almost a year later, I have an " EE WOOD " on the drivers side.
I was lucky enough to find two full replacements (boy they were NOT cheap) that appear to be either NOS or a New Repop. Either way, they look GREAT!
What is the best way to secure these back on to the fender? I believe from the factory, there were clips on the back side. Without removing the fender, I don't think I can re clip them back on.
Suggestions on getting them back in there and to STAY PUT so I am not throwing money away?
As always, thanks for the help!
On one side, I don’t have the holes since it’s a replacement fender from a non-fleetwood. So I ground off the pegs and just put glue on the backside of the letter. On the other side, I have the pegs so I used a little on the back of the letter and a little on the peg. Just be careful putting too much on the peg because if will get messy.