64 Convertible Parts
Hello
Does anyone know who would have a
1) "Top Boot Slide Rail" for my convertible top boot.
2) Driver side solid Fender Trim
I asked Jason and Russ and neither one has one. Any help would be appreciated.
Thanks
Dominic
Replies to This Discussion
-
Permalink Reply by Dennis P. DiBari on
-
Hi Dominic,
I just replaced my passenger side fender trim. Mine is 65 3/4" long; it's a 1964 Series 62. I searched everywhere for a year and finally got it from CPR (Cadillac Parts and Restoration). He is great and runs the CLC 59-60 Chapter. He is in Poughkeepsie, NY. His name is Frank Nicodemus. Even got the clips from him. He'll remember me, as he did some work on my steering column/horn.
Dennis DiBari, Cottekill, NY
Your convertible is great!
-
Permalink Reply by Dominic Salemi on
-
Dennis
Thank you and I also found one on JEGS but not sure it is the correct part. The picture shows correct part but you know how that could go.
Thank you
Dominic
-
-
OK Dom. Keep CPR as a good resource, being you are also in NY.
Dennis
Members
-
Travis J. Hensley Online
-
-
Forum
Anyone Aware of a Raised Roof 75 Series?
Started by Jason Edge in General Discussion 19 hours ago. 0 Replies 0 Likes
I received the email below and did not remember a raised roof 75 series but thought I would post here. Anyone know of or ever hear of this car?"I am a volunteer at Hillwood Museum and Gardens, the…Continue
Gump(Pat Westphal) you’re a gosh darn genius!
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal on Friday. 2 Replies 0 Likes
So I have been having problems with my brake lights. At first I thought it was both sides and turns out it is only the drivers side. Also, I thought the blinker worked and it didn’t and turned out…Continue
Front grill
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari Jul 22. 11 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Steering slack/play
Started by Nile Bolen in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari Jul 21. 4 Replies 0 Likes
I checked the Help page and did a search on the site but didn't see any subjects on steering play/slack. Since I had someone complete a front end rebuild (Kanter kit, all the control arm bushings,…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
