Greetings Everyone.  I read a discussion thread about "radiator and related", covering coolant overflow.  Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac?  Is there if a particular universal reservoir that can be fitted and attached to the radiator support housing or the passenger inner fender?  Then insert the overflow tube into the reservoir?   Thoughts / suggestions? 

I am monitoring coolant overflow and / or possible mixing with the oil.  If an overflow reservoir doesn't clear up the puddle on the garage floor, I will investigate a possible head gasket issue.  

Facebook Facebook

Views: 80

Reply to This

Replies to This Discussion

Several folks run the generic square coolant overflow tank. I see this in 99% of the uses. Amazon.com: Dorman 54002 Engine Coolant Recovery Kit Universal Fit ...

I mount mine on the RF inner fender right behind the radiator core support. 

Thanks Russ.  I'll check out the one you recommend. 

Hi Michael,

    I have a 64 Series 62 and albeit it never had an overflow for coolant, I decided to install one for safe measure.  I found one that fit perfectly between the grill and the metal frame.  Only had to drill one hole (the other was there) and it works perfectly.  My email is ddibari56@gmail.com and can give you a picture and details.

Dennis DiBari, Cottekill NY

Michael,

I sent you an email with the information you requested.

Dennis DiBari

I saw somebody do this a few years back. Thought it was a clever solution

Hi Mike,

     Any luck with the coolant overflow tank we talked about for your Caddy?

Dennis DiBari

RSS

Photos

  • Add Photos
  • View All

Forum

Dino Radiator Leak - Time to Recore!

Started by Jason Edge in General Discussion. Last reply by Bill Wolf 8 hours ago. 36 Replies

I had brought up the topic of radiator leaks as a discussion topic for our Chapter Zoom meet-up this past Sunday and thought I would share on our website for everyone and probably do a more formal…Continue

front seat crest

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf 20 hours ago. 2 Replies

Original seats had a crest on the center arm rest.  Does anybody know where I could embose a crest in new material for a reupolstry?Continue

64 Replacing dash illumination lights-how much has to come out to get to all of them?

Started by Norman Silverman in General Discussion. Last reply by Norman Silverman on Thursday. 11 Replies

Hello AllI have taken off my dash top and started replacing dash bulbs with LED's for greater visibility. Some questions:1) To replace the Gauge bulb it looks like easier access is had by removing…Continue

Correct whitewalls

Started by Richard Stanley in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Wednesday. 3 Replies

 I just replaced my tires from Diamondback (I had bad results in the past from Coker).  It was the second time, due to the age of the tires.  About 18 years ago Diamondback made custom whitewalls…Continue

Tags: width, whitewall, correct

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service