electronic ignition
I was considering adding this petronics system to the 63 model.....
advantages //// disadvantages?
keep in mind, i am complete novice,,
Sincerely
Kim
Replies to This Discussion
-
Permalink Reply by 24ro8f5mbs2jc on
-
Don't have to adjust points. If installing a new coil as well you will get higher voltage = better spark.
Read these three links and you should be good to go:
Pertronix Ignitor Ignition & Flamethrower I, II, and III Compar...
-
Permalink Reply by john chalk on
-
Petronix 3 Kim - just remember you need to rewire in full 12 volts for the petronix ignition itself (inside the dizzy) and the coil but you pick that up off the battery and use the ignition voltage signal to switch the relay. With the 64 429s its pretty easy with the dizzy at the front. I did one for a friend with a 59 and it was a pain getting to the dizzy at the back of the engine = you have to stand inside the engine bay to reach down inside and wire it all in! overall though a great ignition system!
John
Members
Forum
Logans Intake Project, 1964 Fleetwood, Progress Report #2
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 57 minutes ago. 1 Reply 0 Likes
Hello all!Just a short update this evening!I wrestled with the exhaust manifold studs and ultimately chickened out on replacing all 4 of the studs. I only replaced the stud that I spun the threads…Continue
Rear main seal
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson 9 hours ago. 5 Replies 0 Likes
Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue
Scout Shows up in the Garage with "Man Bun" to Work on Cadillac!
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 15 hours ago. 1 Reply 0 Likes
Cheryl brought my 4 1/2 month old boy Scout out to the garage in a man-bun to help work on the Cadillac. Sometimes you just have to roll with it! (I am scared to see who she will "dress up" Bandit…Continue
Logans Intake Project, 1964 Fleetwood, Progress Report #1
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb 23 hours ago. 5 Replies 0 Likes
I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
