To those that have rebuilt their engines:
To start, my 64 Fleetwood does not need an engine rebuild at this time. But eventually, it would certainly be nice. And I wonder, would it be more cost effective and efficient to have a complete secondary engine to rebuild in my free time and as funds allow? Then when ready, pull the old motor and put in the rebuilt one?
To me, that sounds like a sure fire way to not rush things and make sure everything with the rebuilt motor is correct before dropping it into the car.
Just curious on everyone’s thoughts, thanks!
Logan
Tags:
If you don't care about having the original engine in your car, then it's an okay plan. Keeps the down-time to a minimum.
But, then you'll have one needs-a-rebuild engine left over. Do you have the room to store it? I sure don't.
And why would you want to keep the old engine? With the newly rebuilt engine in the car, unless you put a rod through the block it'll probably go 80,000+ miles without needing another rebuild.
My first question is worth addressing: "Is having the original engine of value to you?" Answering that will make the rest of the decisions easier.
Since it can take up to 4-5 months to get an engine rebuilt, it does seem like a good idea to have a spare engine. Just be sure that the engine can be run before being handed over to you. Not having the original engine really isn't a big deal. the VIN is stamped on the engine, so just keep the original engine or block.
Started by Doug Scarrow in Wanted to Buy. Last reply by Doug Scarrow 53 minutes ago. 2 Replies 0 Likes
for close to 20 years I have had a lovely Club Decal on my windshield now I wish to replace the windshield and would love to buy a decal if any one has one available See attached photosContinue
Started by Jordan Johansen-Moe in 1963/64 Cadillac Specific Discussion. Last reply by Jordan Johansen-Moe on Tuesday. 2 Replies 0 Likes
Is anyone here planning on going to the Back to the 50’s car show in Minnesota?
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Jason Edge on Sunday. 2 Replies 0 Likes
Hi allwhere can I find these - 1963 Cadillac Plastic Door Pin Anchors. Mine are from1963 and a little tiredThanksContinue
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Matti Roth Jun 14. 15 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
June 22, 2025 from 8pm to 9:30pm – Zoom
0 Comments 1 Like
© 2025 Created by Jason Edge.
Powered by