I have noticed that after I drive for 5-10 miles or more and then shut off the car, it hesitates when I go to start? Anyone experience this before and if so, what was the fix?
Tags:
Alternators will only produce what is required, and as I recall most alternators actually only produce up to about 2/3's the rated amperage under normal rpm/driving anyway. So with that 55 amp factory alternator it might be producing say up to 30 amps max at any moment under extreme max current draw load. This is why the factor 10 gauge alternator to battery (secondary charging) wire is sufficient ... but one reason why I wanted to move away from the considerably smaller 14 gauge Heartbeat City sources wires reproduced for the 1969 Camaro, and get M&H to produce wires with the correct factory 10 gauge. (I guess even back then, the Cadillacs were pulling much more power than the average Camaro or Mustang).
So, with that 100 amp alternator, unless you are installing a Giga-Splat-Velocity-Blaster in the trunk that draws 50+ amps you are probably never going to draw (ie. the alternator produce) anywhere near 100 amps. If you have the mega-amp-mega-power-draw sound system (that rivals the soundstage at an AC/DC concert), then you might want to get M&H to fabricate a cable with a thicker alternator wire (8 ga, 6 ga, 4 ga, etc).
Great work Dave. It's great when GEN light goes out and it's not overcharging. I remember going through that last year.
Dennis DiBari
Dave, That is great news. If your car is wired correctly, removing the battery cable while running is a quick & easy way to find out if the alternator is working. I actually just ordered a couple of rebuilt alternators through AutoZone today as I had a $45 reward to use, and like to keep a couple of them ready to go on the shelf.
Started by Rob Spring in 1963/64 Cadillac Specific Discussion yesterday. 0 Replies 0 Likes
Hey! I’ve seen the 63/64 power booster and master cylinder combination has been covered very clearly. I’m in the process of replacing mine. I was hoping someone could give me insight on a specific…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Mark Mata yesterday. 1 Reply 0 Likes
I meant to make this a priority over the winter and didn't get that far. I've tried to source all the parts individually, but that is a daunting task. Partly because I don't want to miss any…Continue
Started by Michael Monson in Wanted to Buy. Last reply by Russ Austin on Wednesday. 1 Reply 0 Likes
Hello, possibly looking a neutral safety switch for a 1964 Deville with the TH-400 and tilt steering. Also, possibly looking for an oil filter housing assembly for a 1964 429 motor. Starting to get…Continue
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari on Wednesday. 2 Replies 0 Likes
As they say, Better Late Than Never!I want to give a shout out to 63/64 Chapter Member Alan Grist, who brought his 64 Series 62 Four Window Sedan, to the 2025 CLC Winter Board Meeting in Chattanooga,…Continue
Posted by Chase on March 12, 2025 at 2:05pm 13 Comments 0 Likes
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2025 Created by Jason Edge.
Powered by