Tags:
Thank you, Jason. She’s been a labor (and expense) of love. There are still a few minor things to do, like replace the rear speaker (which seems to have been lost when I reupholstered the seats), and eventually rechrome the instrument cluster bezel and driver’s door window and seat switch bezel, both of which have a little bit of pitting.
Thank you all of your advice and support (and parts!) and everyone in the club.
Mike
Thank you, Tony! And thank you for the reply. My apologies, I thought your post was from Jason. My bad.
i appreciate all of your encouragement and knowledge. Thank you!
Mike
Hi Logan,
I ordered them from Caddy Daddy.
Mike
Thanks! This will be an upgrade in the near future for sure.
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt yesterday. 1 Reply 0 Likes
My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue
Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Saturday. 2 Replies 1 Like
I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Robert Alan Shannon on Tuesday. 9 Replies 0 Likes
I’m starting the complete rear suspension update/upgrade-new springs and shocks,replacing spherical joint and bushings on yoke and control links! Just wondering if there are any tips to help with the…Continue
Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin May 12. 4 Replies 0 Likes
I’m struggling with my TV rod adjustment. I’ve been trying to adjust it as per shop manual, but it’s still not OK. When cold, it shifts smoothly through all four gears, when hot, it hesitates (lots…Continue
Tags: adjustment, rod, TV
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
© 2025 Created by Jason Edge.
Powered by