Need window switch for 1964 Deville convertible
Of course just the drivers window doesn't work
Facebook Facebook

Views: 259

Reply to This

Replies to This Discussion

Hi Phil, you can often pull the case off the switch body, cleans the contacts and bend tabs up a bit and get working again. Might give that a try if not already done.

the bottom of the switch is broken off and the wires no longer are held in--if is jump the wire out the window goes up and down--been this way for a while finally just quit working

Also check for broken wires inside the door jamb wire conduit.

all the wires have been repaired--99 percent sure its the switch

Maybe I could use a new drivers wiring harness for the window instead. Anyone have one

Phil, the drivers door is always the worst for wear. I have yet to bring in a car with all the wires intact. American Auto Wire builds new wire harness's. You just send them your old one.

I believe I just need the plug at the end where the master switch connects mine fell apart if you have the plug with 6" of wire that would be perfect also the drivers window switch is the only one that is inoperable the other windows all work from the master switch

Phil, I have a plug.  Send me an email to;  russ85747@hotmaiil.com

RSS

Photos

  • Add Photos
  • View All

Forum

Front door handle lights not working

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Sunday. 1 Reply

My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue

lighted headlight switch

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Saturday. 2 Replies

I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue

Rear suspension project

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Robert Alan Shannon May 13. 9 Replies

I’m starting the complete rear suspension update/upgrade-new springs and shocks,replacing spherical joint and bushings on yoke and control links! Just wondering if there are any tips to help with the…Continue

TV rod adjustment 1963 Cad

Started by Mark Geertsma in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin May 12. 4 Replies

I’m struggling with my TV rod adjustment. I’ve been trying to adjust it as per shop manual, but it’s still not OK. When cold, it shifts smoothly through all four gears, when hot, it hesitates (lots…Continue

Tags: adjustment, rod, TV

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service