I haven been able to check for the starter items until today, so i went out and noticed a lot of fluids on the ground that had run down towards the front of the car as it was on a slope. so i looked quickly and could see active dripping,, touched it, and it was gas!!!
i opens the hood, and up around the carb, i noticed a puddle of gas ( see picture attached) i had seen this the other night when i was trying to figure out the starter thing and just figured it was from where i had pour some gas in carb to help start and figured it was run off or i had missed some. so i absorbed it, cleaned it up dry. noticed the accelerator pump was a little damp dried it too, and left car as it seemed the starter or straps had been problem,, so i was surprised to see all the gas and fluid underneath,,, i checked the fuel filter and it was dry as well as the hoses., it looks like, but cant be sure, the highest point is the accelerator pump,, now would that continually leak for 4 days with out the engine running to create this kind of leaking ? what would be my procedure from here for diagnosis and repair, if you can tell from the pictures. that little pool is about an inch deep below he carburetor.. so it holding a fair amount of fuel,,guessing about as big as a thumb,, and the squiggly marks on the accelartore pump are gas and liquid below the rubber boot
thanks,,
Tags:
i am adding this since i was fooling around the carburetor, this particular hose seems very loose,, it kind of just popped loose when i was trying to dry out the gas source. should it be that loose or should a clamp be on this,,you can see that its a bit off and not snug up on the metal piece, its out of the front of the carburetor on the bottom
I'm not able to open your pictures. (I'm not sure if its the site or my computer.)
No disrespect Kim, but I think its time to get a mobile mechanic to come around and take a look as I think you're getting in too deep now. I'm sure if one of us was nearby, we'd be around in a flash to help you.... I know I would.
yes,, may well be,,no offense taken, i realize my limitations.
i will note that i did find that big strap from the frame to the starter, it was completely covered up by gunk and goo. i suspect from when the radiator was leaking profusely and the fluids were blowing back under the engine.
i dont under stand why the pictures dont come up,, i get them on mine, but will try again
I did see the original pictures. Might just have been the site behaving bad.
When you post pictures its easier for the reader (us) if the picture is inserted in the post rather than being an attachment.
It is the same procedure as "Uploading Files", except its the "image" button marked in red. Try it next time and you see what happens. Glad you are using pictures as it is a lot easier to see with own eyes than reading a text.
this is free standing gas below the accelerator pump shaft
See my comment on first page for the pcv valve
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 23 hours ago. 3 Replies 0 Likes
I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 6 Replies 0 Likes
So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply 0 Likes
After dinner last night, we went for a quick cruise as the weather was cooler and the sun set was looking really good!Out of nowhere, a pop up shower appeared overhead and down-poured as we were…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by