I haven been able to check for the starter items until today,  so i went out and noticed a lot of fluids on the ground that had run down towards the front of the car as it was on a slope.  so i looked quickly and could see active dripping,, touched it, and it was gas!!!

i opens the hood, and up around the carb, i noticed a puddle of gas ( see picture attached)  i had seen this the other night when i was trying to figure out the starter thing and just figured it was from where i had pour some gas in carb to help start and figured it was run off or i had missed some.  so i absorbed it, cleaned it up dry.  noticed the accelerator pump was a little damp dried it too, and left car as it seemed the starter or straps had been problem,,   so i was surprised to see all the gas and fluid underneath,,, i checked the fuel filter and it was dry as well as the hoses.,  it looks like, but cant be sure, the highest point is the accelerator pump,, now would that continually leak for 4 days with out the engine running  to create this kind of leaking ?  what would be my procedure from here for diagnosis and repair,  if you can tell from the pictures.  that little pool is about an inch deep below he carburetor.. so it holding a fair amount of fuel,,guessing about as big as a thumb,, and the squiggly marks on the accelartore pump are gas and liquid below the rubber boot

thanks,,

Facebook Facebook

Views: 583

Attachments:

Reply to This

Replies to This Discussion

i am adding this since i was fooling around the carburetor, this particular hose seems very loose,, it kind of just popped loose when i was trying to dry out the gas source.  should it be that loose or should a clamp be on this,,you can see that its a bit off and not snug up on the metal piece,  its out of the front of the carburetor on the bottom

Attachments:

I'm not able to open your pictures. (I'm not sure if its the site or my computer.)

No disrespect Kim, but I think its time to get a mobile mechanic to come around and take a look as I think you're getting in too deep now. I'm sure if one of us was nearby, we'd be around in a flash to help you.... I know I would.

yes,, may well be,,no offense taken, i realize my limitations.  

 i will note that i did find that big strap from the frame to the starter, it was completely covered up by gunk and goo.  i suspect from when the radiator was leaking profusely and the fluids were blowing back under the engine.  

Its for your pcv valve. It should have a tight fit and is secured by clamps originally. The pcv valve is the metal thingy these two hoses are attached to.

i dont under stand why the pictures dont come up,, i get them on mine, but will try again 

Attachments:

I did see the original pictures. Might just have been the site behaving bad.

When you post pictures its easier for the reader (us) if the picture is inserted in the post rather than being an attachment.

It is the same procedure as "Uploading Files", except its the "image" button marked in red. Try it next time and you see what happens. Glad you are using pictures as it is a lot easier to see with own eyes than reading a text.

this is free standing gas below the accelerator pump shaft

See my comment on first page for the pcv valve

RSS

Photos

  • Add Photos
  • View All

Forum

Rear Main Seal Oil Leak Fix with Bearing Cap Modification

Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Patrick Westphal 2 hours ago. 13 Replies

Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue

Future of CLC Judging

Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge 3 hours ago. 6 Replies

First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system.  The old system was very good, however, I believe what Bill and the…Continue

front seat crest

Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch yesterday. 3 Replies

Original seats had a crest on the center arm rest.  Does anybody know where I could embose a crest in new material for a reupolstry?Continue

Coolant Overflow Bottle / Reservoir for 64 Cadillac Eldorado

Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf yesterday. 7 Replies

Greetings Everyone.  I read a discussion thread about "radiator and related", covering coolant overflow.  Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac?  Is there if a…Continue

Tags: Radiator, Bottle, Reservoir, Overflow, Coolant

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service