I have a series 62 1963 convertible and under the left fender, near the firewall is a vacuum tank with a "T" and 2 hoses.  On e is disconnected, WHERE do it go????

Thanks

Facebook Facebook

Views: 231

Attachments:

Reply to This

Replies to This Discussion

That is for the power door locks. 

I guess this does directly to the intake manifold?

The large vacuum tank on firewall on left side under left fender is used for cars equipped with vacuum power trunk or vacuum power door locks. The one hose feeds straight back into the cabin for trunk lock and/or door lock operation, while the other line goes across over to the fitting on the back of the intake. 

That back of intake on 63 cars usually has 3 nipples: one goes back up to the connector in center of the large forward wiring harness connector on firewall that in turn feeds Neutral Safety Switch and heat or heat/AC system; one goes up to the vacuum throttle check valve mounted to the throttle relay bracket on firewall; and the 3rd goes over to the power door lock/power trunk vacuum canister in your picture. 

RSS

Photos

  • Add Photos
  • View All

Forum

Front door handle lights not working

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Kurt on Wednesday. 3 Replies

My front door handle lights would not go on when I opened the doors. Bulbs were good and had power to them. Was not getting a ground. The door switch was corroded and wasn't making contact when the…Continue

Vintage Promo Picture #4 - 1963 Fleetwood 60 Special in Nevada Silver

Started by Jason Edge in 1963/64 Cadillac Specific Discussion on Wednesday. 0 Replies

Here is the 4th picture in my collection of "Promo Pictures" - another 1963 Fleetwood 60 Special.  This 60 Special appears to be Nevada Silver, Paint Code 14.  …Continue

Tags: Picture, Promo, Vintage, 1963

lighted headlight switch

Started by Bill Wolf in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Saturday. 2 Replies

I had to replace the heater core in my 63 SDV, so I decided to replace all the dash lights with LED's. and replaced all the vacuum lines. While I was in there, I added a light to the headlight switch…Continue

Blog Posts

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Loud air moving sound within carb with cleaner removed

Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments

While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service