Wiper Motor Relay Coil Sticking
All,
My 1963 Series 62 convertible's wipers sometimes stay on after I turn them off. This is annoying as I usually have to find a speedbump or pothole to hit to turn them off!
The issue is that the relay coil (marked in image below) is sticking. Is there any recommended lubricant or other fix to prevent this coil from sticking? It looks like it would be a hard and tedious job to replace it, if I could even find the right coil.
Any and all thoughts appreciated!
Karl Schwarz
Centreville, VA
Replies to This Discussion
-
Permalink Reply by Kurt on
-
I had that problem. My wipers would also take several seconds to start after after the switch was turned on. In my case it was a very easy fix. I just removed the wiper motor front cover, cleaned up all the old hardened, sticky grease with solvent and re-greased the mechanism. It has worked perfectly since then (10 years). I just used regular bearing grease.
-
Permalink Reply by Karl Schwarz on
-
Kurt, Thanks. I actually did what you described, and it improved things quite a bit, but the sticking relay coil still sometimes causes the problem. What kind of grease did you use to re-grease?
-
Permalink Reply by 3ft7bqmb7dryo on
-
Look here for the problems. Both areas need to move freely.
Members
Forum
Rear Main Seal Oil Leak Fix with Bearing Cap Modification
Started by Kurt in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari yesterday. 14 Replies 4 Likes
Many owners have reported oil leaks at the rear main seal even after replacing the seal, myself included. Recently Tony Lentini found a Serviceman bulletin published in February 1965 which details a…Continue
Future of CLC Judging
Started by Jason Edge in Restoration Discussion. Last reply by Jason Edge on Thursday. 6 Replies 0 Likes
First, A Big Thank You to CLC Chief Judge Bill Anderson for taking on this daunting task of overhauling the CLC judging system. The old system was very good, however, I believe what Bill and the…Continue
front seat crest
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Frank Murch on Tuesday. 3 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
Coolant Overflow Bottle / Reservoir for 64 Cadillac Eldorado
Started by Michael Stinson in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Tuesday. 7 Replies 0 Likes
Greetings Everyone. I read a discussion thread about "radiator and related", covering coolant overflow. Has anyone fitted an overflow reservoir / bottle to their 64 Cadillac? Is there if a…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
