Kim K Kaiser's Discussions (1,247)

Discussions Replied To (941) Replies Latest Activity

"well,, i was back at it,  i followed the 1 plug wire to the cap, looks like it goes…"

Kim K Kaiser replied Sep 10, 2017 to Adding a petronix 1181ls

27 Sep 18, 2017

"im fixin to head back out and get to work on it,, will try to equate the above diagr…"

Kim K Kaiser replied Sep 10, 2017 to Adding a petronix 1181ls

27 Sep 18, 2017

"i never did remove the distributor from the engine, i simple took the cap off,, i di…"

Kim K Kaiser replied Sep 10, 2017 to Adding a petronix 1181ls

27 Sep 18, 2017

"well, here is what i did.from start to finish took off cap, removed points and small…"

Kim K Kaiser replied Sep 9, 2017 to Adding a petronix 1181ls

27 Sep 18, 2017

"well, i finally found the tie in of the cloth resistor wire and the pink wire,  it w…"

Kim K Kaiser replied Sep 9, 2017 to Adding a petronix 1181ls

27 Sep 18, 2017

"ok, went to help forum,  pulled the bracket and grommet from firewall, cut back all…"

Kim K Kaiser replied Sep 9, 2017 to Adding a petronix 1181ls

27 Sep 18, 2017

"after looking at it all again,, i am going to have to pull the upper dash off to acc…"

Kim K Kaiser replied Sep 9, 2017 to Adding a petronix 1181ls

27 Sep 18, 2017

"i ordered some of those snaps for the fuses,, currently, i have the always on power…"

Kim K Kaiser replied Aug 30, 2017 to radio install

9 Aug 30, 2017
Reply by Kim K Kaiser

"ok,, found stumpy fuse, plugged in,, all is well,, old radio works, antenna works an…"

Kim K Kaiser replied Aug 27, 2017 to radio install

9 Aug 30, 2017
Reply by Kim K Kaiser

"do they make a stubby 15 amp fuse,, doesnt appear a long one will fit there..."

Kim K Kaiser replied Aug 27, 2017 to radio install

9 Aug 30, 2017
Reply by Kim K Kaiser

RSS

Photos

  • Add Photos
  • View All

Forum

Bleeding brakes

Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin yesterday. 3 Replies

I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue

Front grill

Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies

Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue

Getting hot when going fast…

Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 6 Replies

So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue

Rainstorm out of nowhere!

Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Monday. 1 Reply

After dinner last night, we went for a quick cruise as the weather was cooler and the sun set was looking really good!Out of nowhere, a pop up shower appeared overhead and down-poured as we were…Continue

Blog Posts

1963 RHS A/C kick panel - photos needed

Posted by SK on June 2, 2025 at 2:20pm 2 Comments

Could someone post front and back photos of the 1963 right-hand kick panel with A/C?

My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.

Many thanks,

-Samu

Edelbrock Carb Block off Plates

Posted by Chase on March 12, 2025 at 2:05pm 14 Comments

Hey guys,

I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…

Continue

'63 Tailfin Tales

Posted by Mark Mata on February 22, 2025 at 5:00pm 9 Comments

New old stock seat material

Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments

I bought this seat material thinking that it’s…

Continue

Events

Videos

  • Add Videos
  • View All

© 2025   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service