Heater-Air Conditioning Vacuum Power Unit 1963 Coupe deVille
I am not having issues with with my vacuum unit but have been looking at what it would take to replace it if became necessary. Can the 2 nuts that hold it to the rear plenum be reached from the inside without removing the plenum? The rear plenum is very close to the firewall and it appears that space is quite limited to access the nuts on the backside of the plenum.
Replies to This Discussion
-
Permalink Reply by Kurt on
-
I did mine working from inside with the glove box liner removed. Posted here https://6364cadillac.ning.com/forum/topics/recirculation-actuator-r...
-
Permalink Reply by John Cason Fudala on
-
The vacuum unit you are showing has already been replaced. The unit I am speaking about controls the flow of air between the floor/ac ducts. It is mounted inside the rear half of the heat/ac assembly and the retaining nuts are facing the firewall.
Members
Forum
Dino Radiator Leak - Time to Recore!
Started by Jason Edge in General Discussion. Last reply by Bill Wolf yesterday. 36 Replies 0 Likes
I had brought up the topic of radiator leaks as a discussion topic for our Chapter Zoom meet-up this past Sunday and thought I would share on our website for everyone and probably do a more formal…Continue
front seat crest
Started by Frank Murch in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Friday. 2 Replies 0 Likes
Original seats had a crest on the center arm rest. Does anybody know where I could embose a crest in new material for a reupolstry?Continue
64 Replacing dash illumination lights-how much has to come out to get to all of them?
Started by Norman Silverman in General Discussion. Last reply by Norman Silverman on Thursday. 11 Replies 0 Likes
Hello AllI have taken off my dash top and started replacing dash bulbs with LED's for greater visibility. Some questions:1) To replace the Gauge bulb it looks like easier access is had by removing…Continue
Correct whitewalls
Started by Richard Stanley in 1963/64 Cadillac Specific Discussion. Last reply by Bill Wolf on Wednesday. 3 Replies 0 Likes
I just replaced my tires from Diamondback (I had bad results in the past from Coker). It was the second time, due to the age of the tires. About 18 years ago Diamondback made custom whitewalls…Continue
Blog Posts
1963 RHS A/C kick panel - photos needed
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Events
Videos
© 2025 Created by Jason Edge.
Powered by
