As I prepare for the CLC Fall Festival next weekend, I find myself finishing up everything on my list that I wanted to get done ACCEPT the lower front grille.
Jason put together a SUPERB front grill for me several months ago and I have been afraid to tackle that job.
I have the whole weekend to get the lower grille out and put back in.
How hard of a job will it be? Looking for any tips and tricks, thank you!
Logan
Tags:
I would use plenty of PB Blaster getting the perimeter fasteners off the old one, use a bright headlamp, and just take your time.
Does the bumper need to come off? It looks like everything should come right out of there!
Shouldn't need to come off. I remove the entire assembly when parting a car. At works you might loose the upper bumper outer to inner fender "hanger" bracket from bottom and loosen the 4 large bumper bracket to frame bolts/nuts to the bumper assembly drop a bit but I don't think you need to drop the entire bumper. Someone may have experience replacing in place and can chime in and I will look at my 64 again later this evening.
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 3 hours ago. 1 Reply 0 Likes
So I am starting to crawl around under Dino seeing what I can fix or upgrade and as I was putting the trans linkage in a few nights ago, the rear trans mount caught my eye. I remembered that these 64…Continue
Started by Dave Fehrle in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin on Thursday. 3 Replies 0 Likes
I have finished replacing all the rear suspension and am at the last item, which is bleeding the rear brakes. I am using the Jason Edge vacuum pump method and all went well with the rear passenger…Continue
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Wednesday. 8 Replies 0 Likes
Hi everyone im currently restoring my my front grill due to some previous clown painting it with silver frost paint and doing a dodgy job I would like to know what parts of the grill are anodised.it…Continue
Started by Mack in 1963/64 Cadillac Specific Discussion. Last reply by Dennis P. DiBari on Tuesday. 6 Replies 0 Likes
So… I do have a few of 63 Coupes, all have same setup with carbs, Pertronix, shroud, new US Radiator radiators etc … but only one of them gets a bit hot when I am hauling faster than 60mph and car…Continue
Posted by SK on June 2, 2025 at 2:20pm 2 Comments 0 Likes
Could someone post front and back photos of the 1963 right-hand kick panel with A/C?
My car didn’t come with the original kick panels, so it's a bit of a mystery to me how I should cut the backing board and carpet to fit around the A/C.
Many thanks,
-Samu
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinuePosted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
July 20, 2025 from 8pm to 9:30pm – Zoom
0 Comments 0 Likes
© 2025 Created by Jason Edge.
Powered by