Last fall I replaced my rear yoke and trailing arm bushings . Now with 410 miles on them the large

  rear trailing arm bushings are done . I contacted Rare Parts the maker and they were defensive and

  wanted me to purchase new ones and if sent the old ones back they,  upon inspection would  reimburse the original seller  (Old Parts) a seller on ebay. Seemed like a lot of hoops to jump through so I inquired at all the

known Cadillac Suppliers and it seems the Rare Parts is the only maker of the RP15606 bushings . Further

 internet searches found this is a common problem. This has led to Dan McNarry and Russ Austin heading up making replacement arms with high tech bushings that do not distort and last. Rare Parts needs to retool and use rubber that will last .  In the mean time DO NOT  purchase trailing arm bushings from them with the

expectation they will last as I assure you they will fail quickly

Views: 1283

Attachments:

Reply to This

Replies to This Discussion

Russ

Do you still have access to the video of the rear end that was a part of the first thread and discusion about Dans arms being tested by you
I think Dans own research video of the problem
Where the wheels are off the ground and turning to show how the rear end
( gear housing ) and drive shaft u-joint were not holding there position in relation to each other that they should be due to the trailing arm bushing requiring replacement
Incorrect alignment could only cause more serious damage to the gearcase bearing seal and u- joint over time
A very good reason to have your trailing arms and bushings in the best possible condition they could be especially if you might be dealing with driveshaft vibration issues of any kind
Then again driveshaft vibration could be 5 other addition things that need to be addressed to correct that problem in total

Enjoy

Tony, the go pro video was while the car was being driven. It showed the pinion angle drastically changing under acceleration and deceleration.  This was with new bushings on the control arms with less than 2 years use.

I do not have the video, but I am looking for it.

Here is the link. Don't confuse the up and down motion of the drive shaft with the axle going up and down to the actual pinion angle changing during hard acceleration.

You can see the angle of the yolk and drive shaft change under acceleration.

https://www.youtube.com/watch?v=kNEiPvx5Rno

This video should be in the video section - under videos for others to view 

Enjoy 

Tony or Russ, You or anyone can take the link and copy to our Videos. Just click on Videos then click +Add. You will need to copy and paste in the link. It would be helpful to include some contextual information so people know what they are looking at.

Love the go pro video allowing one  to do things not possible before it 

viewing the activity under actual conditions while they are happening 

I think I saw another video of the same thing but this  video shows all you need to know about the movement in that area 

this tread has been focused on the TA bushings but the spherical joint above the rear end housing is a big part of keeping the rear in place where it belongs in addition 

that’s a whole other thread I would think 

Thanks Russ for finding and posting the video 

Enjoy 

in addition to the u- joint distortion the rear shocks are effected ( so there condition counts ) and the rear springs seat is shifting a bit as well with the twist up the gear case is doing 

need to tighten up and reduce that movement as much as possible to smooth out the ride of the rear of the suspension in that video 

the go pro brings this type of trouble shooting to a new level of excellence literally putting your eyes on the problem —- Nice ! 

Enjoy 

i used the McNarry replacements on my 63 per suggestion from Russ,, my back end wobble at 63 -65 mph went away,, really smoothed it out for me...  i was happy with the move

Ronnie and Doug 

The owners of our cars need your help 

Do pls take the time to return you bad bushings to Glen at Rare Parts 

If he does not get them back he has no way of looking into the problem and removing the bad bushings from his inventory if they are found to be that 

He is very interested in looking into the problem but can do nothing without retuned bushings to track down the problem so he can identify the bad rubber bushing batch ( he outsources the rubber bushings ) 

You will get a complete refund if a problem is found and I am sure we found an issue with a run of  bad rubber bushings ( my best guess ) 

I have to say the entire Cadillac community will be a better place ——if you follow up on this as these bushings are used from 58 thru 64 making  for a much larger problem for the  Cadillac community across the board regarding the bushings durability 

Hope we can —count on you to help rescue a lot of future Classic Antique Cadillac owners ( as we are ) from having had the rear control arm bushing short lived issue in the future 

Do pls advise if we can get the parts back to Glen —-Thx

Enjoy 

It will probably be sometime in the fall when I will be able to swap out the rear links on my 64 Deville, at that time I will send them to Rare Parts.

Kim

Thanks for your feed back on Dan McNarry rear control arms 

Good to know they tightened up your rear suspension at higher speeds 

Dan’s have been working out great for those who have installed them with all good feed back 

I am doing the best I can to correct the problem with the short lived CA bushings currently on the market for the —stock  CA bushings 

Enjoy 

Ronnie 

Thank you —as that will be helping many of our Cadillac owners when this bushing issue finally gets resolved for the better 

Enjoy

RSS

Photos

  • Add Photos
  • View All

Forum

Power Brake Booster

Started by Stephen A. Pechenik in General Discussion. Last reply by Tony and Ginny 429 2 hours ago. 4 Replies

Hello Co-Members,I recently purchased a  low mileage1963 Sedan Deville Park Avenue.  It is extremely solid and runs well.  Neverthelss, it has minor problems that need to be addressed before I can…Continue

Jeremy LeBlanc

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 7 hours ago. 4 Replies

Jeremy I am very interested in learning all you can tell me and the community about your engine swap to the 2019 LS2 L96 Silverado engine and 6L90 trans you installed in your 63Any details you could…Continue

Tags: 63, to, swap, engine, Silverado

Dan McNarry

Started by Tony and Ginny 429 in 1963/64 Cadillac Specific Discussion. Last reply by Tony and Ginny 429 9 hours ago. 5 Replies

Dan Have you come up with any solution for the front bushings of the rear trailing arms of our year cars ?I thought you had suggested you were thinking about what you might do about that Stay Safe Continue

Classic Cadillac Parts For Sale - Misc Items

Started by Jason Edge in For Sale. Last reply by Jason Edge 21 hours ago. 178 Replies

I have posted a few Misc items over on my Classic Cadillac Parts Facebook page at…Continue

Tags: classic cadillac parts, classiccadillacparts

Blog Posts

1964 Cadillac fleetwood sixty special vanilla top windshield needed

Posted by Pablo on April 5, 2020 at 10:00pm 3 Comments

If anybody has or know where Can I get a windshield glass for my 1964 Cadillac fleetwood sixty special with vinyl  top? I will appreciate any info.

Thank you very much

How to sensibly deal with the Corona Virus

Posted by Jeff Kinzler on March 14, 2020 at 5:02pm 6 Comments

https://theamericanscholar.org/covid-19-a-primer/

I found this very helpful, written by a knowledgeable authority in public health. 

Remember, Viruses are not spread by Cadillacs so get out and drive!


Safe & Healthy travels. 

Jeff Kinzler

1963 Eldorado convertible boot

Posted by Les Eastling on February 27, 2020 at 10:33am 1 Comment

I need a used convertible boot for a 63 Cadillac convertible - condition or color is not an issue since it will be used as a pattern for making a new one. One from either a 62 series convertible or an Eldorado would work. I know I am searching for hen's teeth here... but you never know unless you ask!

Videos

  • Add Videos
  • View All

© 2020   Created by Jason Edge.   Powered by

Badges  |  Report an Issue  |  Terms of Service