Rebirth of a Cadillac....
Rebirth of a Junk Yard 1964 Cadillac in Upcoming January Newsletter.... stay tuned
Replies to This Discussion
-
Permalink Reply by 3n49omug8n28i on
-
Looks like my car just a little rougher around the edges. That looks like a Canadian car from the Ottawa area that I've read about before.
-
-
Very nice looking great potential!
-
-
This car has no business sitting in a salvage yard; looks straight and mostly complete. What the heck are some people thinking? Just unreal.
-
-
Sweet!
-
Permalink Reply by Jason Edge on
-
Here's an excerpt of this car's story, which will be published in a few days in our January Newsletter:"When I raised the hood what I saw was bad enough to bring tears to your eyes. He had used a cutting torch to remove the engine and transmission. In the process he had cut EVERYTHING. All the brackets for the alternator and power steering pump were cut, all the supports for the transmission were cut, all the power steering hoses, rad hoses and transmission cooler lines were cut along with most of the wiring harness. He had also cut the engine mounts- all with a torch. I knew this was going to make this restoration that much harder. Looking at this massacre, I became even more determined to bring her back. "Stay tuned for more...
-
-
Could this be my long lost 63?
-
-
No this is a 1964 4 Window Sedan de Ville. Scroll up to the top and you will see a picture.
-
-
Jason, That sounds interesting and I'm looking forward to reading the full story. From what I have read here, the car sounds like a lost cause and if it was me doing the restoration, I'm thinking I would have kept looking for another car to start with even though the exterior looks solid and straight.
-
-
Full story just posted - www.newsletters.6364cadillac.com
-
-
You'd wanna kill the old guy for what he did to remove the olds engine.
Good save of a 64 though and a nice feel good story.
-
-
Interesting read and a good story. That would be a real bummer to buy the car only to have it butchered by the seller before receiving it. The buyer did mention he had heard that the junkyard owner was a crusty old guy but that's still seriously uncool.
-
Permalink Reply by Chris Codd on
-
Is this the guy from YouTube that goes by Cadillacguy100 because this car looks exactly the same as his?
Members
Forum
Logans Intake Project, 1964 Fleetwood, Progress Report #2
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Russ Austin 1 hour ago. 1 Reply 0 Likes
Hello all!Just a short update this evening!I wrestled with the exhaust manifold studs and ultimately chickened out on replacing all 4 of the studs. I only replaced the stud that I spun the threads…Continue
Rear main seal
Started by Phillip Hill in 1963/64 Cadillac Specific Discussion. Last reply by Michael Monson 9 hours ago. 5 Replies 0 Likes
Hi Everyone can somebody tell me where I can get a reliable rear main seal?I have done the end cap modification and replaced the seal twice,after around 500 miles it starts to leak again,not as bad…Continue
Scout Shows up in the Garage with "Man Bun" to Work on Cadillac!
Started by Jason Edge in General Discussion. Last reply by Dennis P. DiBari 15 hours ago. 1 Reply 0 Likes
Cheryl brought my 4 1/2 month old boy Scout out to the garage in a man-bun to help work on the Cadillac. Sometimes you just have to roll with it! (I am scared to see who she will "dress up" Bandit…Continue
Logans Intake Project, 1964 Fleetwood, Progress Report #1
Started by Logan Robb in 1963/64 Cadillac Specific Discussion. Last reply by Logan Robb 23 hours ago. 5 Replies 0 Likes
I plan to do a full write up when this project is complete, however, I figured someone may get some benefit of seeing the progressions I make and the steps I took to get there. This also is a good…Continue
Blog Posts
Edelbrock Carb Block off Plates
Posted by Chase on March 12, 2025 at 2:05pm 14 Comments 1 Like
Hey guys,
I have installed the same Edelbrock carb and have done everything the same as Jason’s carb and intake project. In the spring and summer months the car starts, runs and idles great! In the fall and winter months on a cold start, the car starts awful and wants to die until it warms up. I have to keep my foot on the throttle until it warms up or it will idle just terrible and try to die. Once it’s warm, it runs fantastic! Whats going on here? I was thinking of removing the…
ContinueNew old stock seat material
Posted by Ray Schick on August 22, 2024 at 6:25pm 2 Comments 0 Likes
I bought this seat material thinking that it’s…
Loud air moving sound within carb with cleaner removed
Posted by Dave Fehrle on March 23, 2024 at 3:23pm 8 Comments 1 Like
While checking my Carter carb with engine running, I took the air cleaner off and there was a very loud hissing sound of air. I placed a piece of paper over the carb and it didn’t move up or down, is this normal?
Events
© 2025 Created by Jason Edge.
Powered by
